Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Fast, Reliable Electric Gate Repair Across Lantana
Electric gate repair in Lantana typically runs $180-$340 for most diagnostic and component-level fixes, while a full operator replacement with marine-grade hardware usually lands between $1,200 and $2,800 parts and labor. We get to Lantana neighborhoods quickly, usually same day or next morning, because we carry the boards, arms, sensors, and weather-sealed enclosures these coastal gates actually need. Call (940) 412-7340 and a live person answers, day or night. You’ll get a written price before any work starts, not after the gate is already in pieces.
Why Portcullis Gate Repair Is Lantana’s Preferred Electric Gate Repair Company
Lantana homeowners deal with a specific kind of gate failure that inland towns rarely see. We’ve worked gates on the lagoon-side streets off Ocean Avenue, through the older concrete-block neighborhoods behind Lantana Road, and in the manufactured home communities where the gate hardware was never really up to salt air in the first place. When you call us, the technician who shows up already knows the difference between an Orlando gate failure and a Lantana gate failure. That matters.
Our Electric Gate Repair team is background-checked, uniformed, and trained across nine operator brands including LiftMaster, Linear, Viking, DoorKing, and Ghost Controls. Every repair is covered by the Kingswell Guarantee: a written price before the work begins, a real arrival window, a clean job site, and the repair guarantee in writing. If the fix fails within 365 days, we return and correct it at no charge. That’s the 365-Day Done Right Promise, and it’s stamped on every invoice we hand a Lantana homeowner.
Gate Access Control in Lantana
Gate Access Control is the system that decides who gets in and who does not: keypads, remotes, intercoms, vehicle loop detectors, and safety photocells. In Lantana, wind-driven rain and salt spray eat at these components faster than almost any other part of the gate. A keypad that works fine in Fort Worth can show green corrosion on the contacts after two summers on the lagoon. Most keypad or remote receiver repairs in Lantana run $165-$320, and we carry common parts on the truck so we’re not running back and forth across the metro.
Keypads, Remotes, and Vehicle Detection
When a keypad intermittently stops accepting codes or a remote only works from ten feet away, the fix is usually straightforward: clean or replace the corroded contacts, re-seat the antenna connection, or recalibrate the loop detector sensitivity. We also re-seal the housing with marine-grade gaskets so the next salt-laden storm doesn’t undo the repair.
Safety Photocells and Edge Sensors
Florida code requires entrapment protection on automatic gates, and Lantana’s storms knock photocell beams out of alignment constantly. If your gate reverses for no reason or refuses to close, the photo-eyes may simply be misaligned, but we also check for water inside the sensor housings, which is the more common culprit here. A sensor replacement or realignment in Lantana runs $140-$240.
Commercial Gate Operator in Lantana
A Commercial Gate Operator is the heavy-duty motor and drive unit that moves a larger gate, often at a business entry, community entrance, or marina access point near the Lake Worth Lagoon. These units cycle hundreds of times a day, and in Lantana they cycle in salt air. Most commercial operator repairs here run $450-$1,100 for drive component replacement, while a full operator swap with marine-rated hardware usually lands between $1,800 and $4,200 depending on the gate’s size, weight, and duty cycle.
Duty-Cycle Failures and Control Board Replacement
A commercial operator that runs more cycles per day than it was rated for burns out its capacitor or drive gear early. We see this at lagoon-adjacent businesses where the gate never stops moving during season. We size the replacement to the actual use pattern, not just the old unit, and we document the rating on the quote so you know what you’re paying for.
Storm Hardening for Commercial Gates
Business owners in Lantana need gates that survive a named storm without ripping off the hingepost or flooding the control board. We re-torque posts, add corner bracing where the wind load is worst, and move control boards out of low-lying enclosures where standing water collects. We’ll give you a written price for the whole hardening package before any bolt turns.
Trusted Brands We Service in Lantana
We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule operators across Lantana. Because we’ve been running these routes since 2008, we keep the most common boards, arms, and weather-sealed enclosures stocked locally, which means most Lantana repairs are done in one visit. If your gate runs on a Viking or a DoorKing, our tech already knows the quirks of that specific system before the truck pulls up.
Common Electric Gate Repair Problems We See in Lantana Homes
- Salt-corroded control boards. Onshore wind off the Intracoastal pushes salt into the operator housing, and the circuit board fails in five to seven years instead of fifteen. The fix is often a board swap with a marine-grade coating, not a whole new operator.
- Saturated footings that let the gate sag. After heavy rain, the ground around the hinge post stays wet for weeks. The post shifts, the gate panel sags, and the operator strains against a panel it was never designed to drag. We re-set the post, true the panel, and adjust the operator.
- Stuck or seized hinges from salt and UV. The combination of salt spray and a full day of Florida sun seizes residential-grade hinges fast. We swap in stainless or coated hardware that holds up against the lagoon air.
- Misaligned photo-eyes after wind events. A squall will knock the photocell brackets just enough that the beam misses. The gate reverses constantly or won’t close. We re-align the sensors and seal the housings.
Pricing for Electric Gate Repair in Lantana, TX
Here’s what Lantana homeowners should expect to pay. A diagnostic service call runs $85-$125, and that amount is credited toward the repair if you approve the work. Keypad or remote receiver repair: $165-$320. Safety sensor replacement: $140-$240. Control board replacement: $280-$600. Swing gate actuator or arm replacement: $380-$750. Full operator replacement with marine-grade hardware: $1,200-$2,800. Commercial operator work starts around $450 and runs up depending on duty cycle and gate size. Every quote is written, agreed to, and signed before the first tool comes off the truck. Call (940) 412-7340 for a free estimate.
We Also Serve Cities Near Lantana
While this page is about Lantana, our crews regularly work the surrounding area. We take the same Kingswell Guarantee and the same written-price rule to Houston, San Antonio, Dallas, and Fort Worth. If you’re outside Lantana but nearby, call and we’ll tell you straight whether we can get to you today or tomorrow, and what the drive time will cost you, if anything.
Serving Lantana, TX - Our Local Coverage Area
We’re based in the Lantana area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Lantana
Every automatic gate operator has a manual release mechanism, usually a pull cord or a keyed release on the side of the motor housing. Pull that release and you can push the gate open by hand. If the gate was forced while powered, the arm may be bent or the gear may be stripped, and you should call (940) 412-7340 for a repair quote rather than forcing it again, which can damage the operator further.
Because Lantana sits on the Lake Worth Lagoon, nearly every property is within a half-mile of tidal salt water. Salt-laden wind gets into the motor housing, corrodes the circuit board and drive gear, and kills the unit in five to seven years instead of the fifteen-plus you’d see inland. Replacing with marine-grade hardware costs more up front but lasts three times as long here.
The panel is rarely the problem. The post footing is. Lantana’s sandy soil gets saturated in a storm, the footing shifts, the panel sags, and the operator drags a gate it was never designed to carry. We re-set and brace the post, true the panel, and check the operator for damage before quoting a fix. Call (940) 412-7340 for a free assessment.
Yes. Florida requires entrapment protection on automatic gates, and Lantana’s wind storms knock photo-eye beams out of alignment constantly. If your gate reverses for no reason or refuses to close, the photo-eyes are usually misaligned or waterlogged. We realign or replace them for $140-$240 and seal the housings against the next squall.
If the operator is seven years old or older and the circuit board and drive gear both show corrosion, replacement with a marine-grade unit usually costs less over the next five years than patching the old one twice. We’ll show you the corrosion, quote both options in writing, and let you decide. Call (940) 412-7340 and we’ll walk you through it.
Written by Dean Prescott, Owner at Portcullis Gate Repair, serving Lantana since 2008.





Before
After
Before
After
Before
After