Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Whittier, CA
We’re Portcullis Gate Repair, and we fix, install, and automate gates across Whittier. Most of our work here falls into two camps: hillside estate gates that have drifted out of square on a slope, and older flatland gates whose posts gave up years ago but were patched instead of replaced. If your gate groans, sags, or stopped responding to the remote, call (940) 412-7340 and we’ll give you a written price before a single bolt is turned.
Why Whittier Homes Are Different
Whittier doesn’t wear the same as Pico Rivera or Santa Fe Springs. Up in Friendly Hills and Whittier Hills, driveway gates sit on actual grades, and gravity works on them around the clock. A gate that looks square at the latch is often fighting its own weight because the hinge posts were set plumb on a slope that has since settled. We correct that by re-plumbing posts and shimming hinges so the gate hangs level again, not by cranking the operator tighter and hoping.
The flatlands tell a different story. Blocks of 1930s-to-1960s bungalows and ranch homes still have their original wrought iron and chain-link gates, and the Whittier Narrows earthquake of 1987 left a quiet mark on those foundations. Posts that cracked then were often patched with concrete and left slightly off-plumb. A gate can look fine for decades until Santa Ana winds slam it against the stop and the underlying lean finally shows. When we reset a post in Whittier, we check what it’s sitting in, not just what it looks like above ground.
Our Main Whittier Services
Three jobs keep our trucks in Whittier all week: repairing gates that won’t swing or slide properly, installing new ones, and getting electric operators working again. Each has its own detailed page below.
Gate Repair in Whittier
Most Whittier repair calls start with a gate that drags, sticks, or sits crooked in its opening. On hillside properties that usually means the hinges have taken unequal load and the frame has twisted. On flatland homes it’s more often corroded posts, worn rollers on slide gates, or a latch that no longer catches. We replace hinge hardware, weld cracked frames, re-set posts, and square the gate before we leave. You get a written price first and a one-year written guarantee after. Details are on the Gate Repair in Whittier page.
Gate Installation in Whittier
A new gate in Whittier has to match more than the fence line. Driveway gates on sloped lots need heavier posts and operators rated for the grade, and older flatland yards often need the old footing broken out before a new post can go in straight. We measure, dig, set, hang, and adjust every new gate ourselves, and we quote the full job in writing before we start. See what’s involved on the Gate Installation in Whittier page.
Electric Gate Repair in Whittier
When an automated gate stops opening, the problem is usually the operator, the sensor loops, or the power delivery, not the gate itself. Whittier’s Santa Ana winds add another failure mode: gates slamming against their stops hard enough to knock limit switches out of adjustment. We diagnose electric gates on the spot, carry parts for major brands, and tell you the repair cost before we touch the panel. Full scope is on the Electric Gate Repair in Whittier page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Whittier
Our technicians train on FAAC, BFT, Linear, and Viking operators, among others, and keep common parts on the truck: control boards, limit switches, receivers, and capacitors. On most electric gate repairs in Whittier we can finish the same visit rather than ordering parts and coming back. See our brands for the full list.
Pricing for Gate Company in Whittier, CA
| Service | Typical range in Whittier |
|---|---|
| Gate hinge replacement (pair) | $180 - $420 |
| Welded gate-frame repair | $150 - $450 |
| Post re-set in concrete | $220 - $600 |
| Chain-link gate replacement | $280 - $600 |
| Wrought iron gate replacement | $600 - $1,600 |
| Slide gate roller replacement | $200 - $500 |
| Gate latch / hardware replacement | $90 - $240 |
| Operator control board replacement | $250 - $600 |
| Sensor loop (loop detector) repair | $180 - $450 |
| Photocell sensor replacement | $120 - $300 |
Two things push Whittier prices toward the upper end of these ranges: the slope work in the hills, which takes longer to square correctly, and the old footings in the flatlands, which often need full removal before a new post can go in. Whatever the number is, you’ll see it in writing before we begin, and that written price is what you pay.
Neighborhoods We Serve in Whittier
We work across the city, from the hills to the historic flatland grid. Our typical response in Whittier is same-day or next-day for repair calls, depending on where the day’s route stands.
- Friendly Hills
- Whittier Hills
- Uptown Whittier
- Parnell Park
- Whittier Boulevard corridor
Service Area – Cities Near Whittier
Besides Whittier, our crews regularly run to the neighboring cities. If you’re in Pico Rivera, CA, South El Monte, CA, Hacienda Heights, CA, or Montebello, CA, the same written-price guarantee applies, and we can usually reach you within the same day or next morning.
Serving Whittier, CA - Our Local Coverage Area
We’re based in the Whittier area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Whittier
For a stuck-open gate or one that won’t secure, we typically arrive the same day or next morning in Whittier, depending on call volume. Call (940) 412-7340, a live person answers around the clock, and we’ll give you a real arrival window, not a vague “sometime tomorrow.”
Whittier’s older neighborhoods don’t usually require permits for a like-for-like gate swap, but hillside estate communities may have CC&Rs governing gate height, finish, and automation. We’ll flag the question early and work with your community’s standards, but the approval itself sits with you and your HOA.
Yes. We do free assessments for Whittier homeowners, and we’ll tell you honestly whether a post re-set will fix it or whether the frame is beyond saving. You’ll get a written price before any work starts, and nothing gets taken apart until you approve the number. Call (940) 412-7340 to schedule one.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Whittier Customers Say
"The opener gave out and we were manually pushing the gate for a week. Portcullis got us in quick, swapped the opener, and set up the remotes for both our cars. Great to have it working again."
- Priscilla Nava"Our driveway gate stopped halfway and wouldn't close, which is a problem when it's the only thing between the street and the yard. They came out same day, replaced the motor, and it's smooth again."
- Leonard Pace"Gate wouldn't respond to the remote or the keypad. Turned out to be the control board. They had the part and swapped it the same visit. Quoted it first, no surprises."
- Everett Shaw