Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Calabasas, CA
Gate repair in Calabasas means working on some of the heaviest, most ornate automated gates in Los Angeles County, most of them on large custom estates where the gate is as much architectural statement as it is security hardware. The combination of Santa Ana wind loads, triple-digit summer heat, and aging operators from the original 1980s and 1990s build-out keeps our trucks busy year-round here. If your gate is stuck, grinding, sagging, or refusing to close, call (940) 412-7340 and we’ll give you a written price before any work starts.
Why Calabasas Homes Are Different
Calabasas is arguably the most gate-dense residential community in greater Los Angeles. Walk through The Oaks of Calabasas or Calabasas Park Estates and you’ll see layered access control: a community perimeter gate at the entrance, then an individual automated estate gate at nearly every lot behind it. That’s two systems to service per property, often two different brands, and two different sets of expectations about noise, speed, and appearance.
The housing stock compounds it. Most of these homes were built between the mid-1980s and early 2000s in Mediterranean, Spanish Colonial, and Tuscan Revival styles, and nearly every one carries a decorative wrought iron or heavy-gauge aluminum automated driveway gate as a design standard, not an afterthought. The original gate operators from that era, typically Eagle, DoorKing, or Linear units, are now well past their intended service life and failing at a predictable clip. What’s also predictable is the wind. Calabasas sits where the Santa Monica Mountains meet the Simi Valley corridor, a natural funnel for Santa Ana events that bend swing-gate arms, strip hinge welds, and knock automated gates off their travel limits. We see that seasonal damage every year, and it’s usually repairable the same visit if the hinges haven’t been run bent for months.
Our Main Calabasas Services
The two calls we run most in Calabasas are repair jobs on existing gates and full replacements where an estate gate has finally outlived its operator, its hinges, or both. Here’s how each works locally.
Gate Repair in Calabasas
Most Calabasas repair calls involve a gate that’s sagging, scraping the driveway, or not closing fully. On older estates, the culprit is usually a worn hinge weld or a bent actuator arm, the motorized arm that physically pushes the gate open. We cut out the failed section, reweld and reinforce, and set the travel limits so the gate sits square in its track again. Because so many Calabasas communities have HOA aesthetic standards, we match the finish and hardware style rather than bolting on whatever’s on the truck. Gate Repair in Calabasas has full details and pricing.
Gate Installation in Calabasas
A Calabasas gate installation usually means removing an original 1990s operator and rail system and replacing it with a modern unit sized for a much heavier gate than the original spec. On properties in the High Fire Hazard Severity Zone, LA County requires a Knox key switch for fire department override on permitted installs or replacements. We handle that as standard on every permit-pulled job here. We also work within HOA approval requirements before any metal gets cut. Gate Installation in Calabasas covers the full replacement process and what to budget.
Electric Gate Repair in Calabasas
Electric gate repair in Calabasas is about diagnosing what failed before swapping parts. The most common culprits we find are cooked circuit boards, burned-out capacitors, and degraded hydraulic fluid seals, all of which fail faster in the triple-digit summer heat this valley gets. If your gate opens but won’t close, or the keypad stopped responding, we trace the circuit, not just the symptom. We keep common boards and remotes for DoorKing, Linear, and Elite systems stocked locally to shorten turnaround. Electric Gate Repair in Calabasas has line-item pricing and symptom-by-symptom guidance.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Calabasas
Our techs carry parts and programming tools for the brands we see most in Calabasas: DoorKing, Elite, and Viking on the commercial and community side, Ghost Controls on newer estate installs. We stock common boards, remotes, and limit switches locally, which usually means a same-week repair rather than a two-week parts wait. See our brands page for the full lineup.
Pricing for Gate Company in Calabasas, CA
| Service | Typical range in Calabasas |
|---|---|
| Swing gate actuator swap | $480-$1,100 parts and labor |
| Gate hinge replacement (welded, both hinges) | $350-$900 |
| Circuit board replacement | $250-$650 |
| Bent or stripped gate wheel replacement | $150-$400 |
| Gate safety sensor alignment or replacement | $180-$450 |
| Keypad replacement | $220-$500 |
| Remote programming (per remote) | $60-$150 |
| Full gate operator replacement | $1,800-$4,500 |
| Wrought iron gate restoration (sand, prime, repaint) | $900-$2,800 |
| Knox switch installation (fire override) | $350-$750 |
Prices in Calabasas run toward the upper end of these ranges when we’re dealing with a heavy custom iron gate, a long driveway requiring a higher-horsepower operator, or HOA finish requirements that add fabrication time. Whatever the number, you get it in writing before a single bolt is turned. The price we quote is the price you pay.
Neighborhoods We Serve in Calabasas
Our trucks cover the full Calabasas area from the 101 up into the hills, including the gated communities where access coordination and HOA patrols are part of the job. We plan our Calabasas routes daily, so response times are typically same-day or next-day depending on call volume.
- The Oaks of Calabasas
- Calabasas Park Estates
- Mountain Park
- Mulwood
- Calabasas Hills
Service Area – Cities Near Calabasas
While this page focuses on Calabasas, we also run regular routes through the surrounding communities on both sides of the 101. If you’re in Topanga, CA, Agoura Hills, CA, Oak Park, CA, or Westlake Village, CA, we can schedule you on the next available Calabasas-area day. Each of those pages has local pricing and conditions specific to that city.
Serving Calabasas, CA - Our Local Coverage Area
We’re based in the Calabasas area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Calabasas
Most Calabasas calls are handled same-day or next-day. We run daily routes in the area and when you call (940) 412-7340, a live person gives you a real arrival window, not an automated promise. Emergency calls, like a gate stuck open or blocking the driveway, get priority on the schedule.
For repairs that don’t change the gate’s appearance, usually not. For anything involving finish, material, or a full replacement, many Calabasas HOAs require written approval first. We prepare the spec sheet and photos your board wants to see, and we don’t start work until the approval is in hand.
If the operator is being replaced like-for-like, most Calabasas jobs don’t need a permit. If the gate, operator, or power run is new, you’ll typically need a permit, and properties in the LA County High Fire Hazard Severity Zone also need a Knox key switch for fire department override. We handle the paperwork on permit-pulled jobs. Call (940) 412-7340 for a free estimate on your specific property.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Calabasas Customers Say
"Installed a new gate for us after the old wooden one rotted out. Clean work, showed up on time both days, and the written price didn't change. It swings perfectly."
- Donna Kirkpatrick"Gate was dragging and screeching across the driveway. I figured I'd need a whole new setup. He adjusted the track and rollers and it was a fraction of what I expected. Honest work."
- Omar Haddad"Our intercom and gate motor both quit. They fixed the whole system in one visit and explained the warranty clearly. On time, polite, and tidy. Can't ask for more."
- Yvette Marchetti