Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Electric Gate Repair Across Lantana
Electric gate repair in Lantana typically runs $185-$520 for most common fixes like operator board replacement, hinge work, or sensor realignment, and we can usually get a technician to your property the same day you call. Lantana’s location on the Lake Worth Lagoon means gate hardware here corrodes fast, and we’ve spent years learning exactly which components fail first in this salt air. Call (940) 412-7340 for a free estimate, and you’ll get a written price before any work begins.
Why Portcullis Gate Repair Is Lantana’s Preferred Electric Gate Repair Company
Lantana homeowners call us because we answer the phone at 2 a.m. when a gate won’t close and a car is stuck inside the driveway. Dean Prescott, our owner, has built our reputation around the Kingswell Guarantee: a written price before work starts, a real arrival window, a clean job site, and a written warranty on every repair. If the fix fails within 365 days, we come back and correct it at no charge under our Done Right Promise. That’s not a franchise slogan. It’s stamped on every invoice we hand to a Lantana customer.
Our technicians know the difference between a gate that failed from age and one that failed from salt spray off the Intracoastal. That matters when you live near Hypoluxo Road, Ocean Avenue, or any street within a half-mile of the lagoon. The same repair done wrong lasts six weeks. Done right, it lasts years. We send background-checked, uniformed techs who arrive with the parts they’re likely to need for your specific operator brand, whether that’s a Linear arm on a canal-front property or a DoorKing slide operator at a small HOA entrance.
Gate Access Control in Lantana
Gate access control in Lantana means the keypad, card reader, intercom, or telephone entry system that tells your gate operator when to open and for whom. In a town where many homes sit on or near the water, these components take more abuse than the motor itself. Keypad buttons corrode from salt air, wiring connections green out, and card readers get finicky after a few humid summers. A replacement keypad for a residential gate in Lantana typically runs $140-$260 installed, while a new telephone entry or card-access system for a small commercial property usually falls between $700 and $1,400 depending on wiring and the number of credentials.
Telephone Entry and Intercoms
Older Lantana buildings often have telephone entry systems that predate current weather-sealing standards. We replace corroded keypads, upgrade call boxes to newer models, and re-terminate wiring that’s been sitting in salt-laden air for a decade. The fix is usually less expensive than a full operator swap, and we’ll tell you the difference honestly.
Keypad and Card Reader Replacement
If your keypad works intermittently or some digits don’t respond, you’re likely dealing with corroded contacts rather than a programming issue. We stock common replacement keypads for Linear, DoorKing, and Viking systems, which gets most Lantana access control issues resolved in a single visit.
Commercial Gate Operator in Lantana
A commercial gate operator in Lantana is the motor-and-control unit that cycles a sliding or swing gate at a business, marina, church, or small community entrance. These units cycle dozens or hundreds of times a day, and Lantana’s salt air works on the circuit boards and drive gears even when the gate isn’t moving. A typical slide gate operator replacement for a small commercial property in Lantana runs $1,800-$3,600 parts and labor, depending on horsepower, brand, and whether existing conduit and safety devices can be reused. Swing gate operator replacement for a commercial entry usually falls between $1,500 and $2,900.
Marina and Waterfront Entries
Lantana has more than its share of marinas, boatyards, and waterfront businesses, and their gates sit closer to the lagoon than almost anywhere else in Palm Beach County. We specify marine-grade operators and corrosion-resistant fasteners for those jobs, because a standard commercial unit installed near the water can show terminal board failure in three years.
HOA and Small Community Gates
For Lantana’s small condo and community gates, we handle operator swaps, safety loop replacement, and photo-eye repair on the same brands HOAs already have on the ground. We also provide written documentation so boards and property managers have a record of what was replaced and why, plus the warranty in writing.
Trusted Brands We Service in Lantana
We service Linear, DoorKing, Viking, Ghost Controls, and six other major gate-operator brands. Our techs arrive already knowing how your specific unit behaves, which matters when a Lantana home has a Ghost Controls swing arm on the lagoon side of the house and corrosion has eaten the limit switch wiring. We keep common parts for these brands on the truck, so most repairs don’t require a follow-up visit. When a specific board or arm isn’t on hand, our parts suppliers deliver fast enough that you’re rarely down more than a day or two.
Common Electric Gate Repair Problems We See in Lantana Homes
- Flooded motor housings: South Florida’s 60-plus inches of rain finds its way into operator housings that weren’t sealed for this climate. Standing water shorts the control board, and the fix usually means drying and treating the board or replacing it outright.
- Salt-corroded hinges and posts: Homes built in the 1950s through 1970s often have original gate hardware never intended for a coastal environment. Hinges seize, posts rust at the base, and the gate starts dragging against the ground.
- Wind-load damage from named storms: Solid infill swing gates catch a lot of wind during a hurricane. The hinge post bends or pulls, saturated footings in Lantana’s flat, low-lying soil lose their grip, and the gate sags even after the panel itself is repaired.
- Corroded safety sensor contacts: Photo-eyes and edge sensors sit close to the ground and take the brunt of salt spray. When their contacts corrode, the gate either won’t close or reverses for no reason, which is a safety problem as much as a convenience one.
Pricing for Electric Gate Repair in Lantana, FL
Most electric gate repairs in Lantana fall between $185 and $520. A capacitor or limit switch replacement runs $185-$260, a keypad swap is $140-$260 installed, and a full control board replacement for a residential operator typically runs $280-$480. Motor or gearbox replacement on a swing or slide operator runs $350-$700 parts and labor. Commercial operator replacement is a bigger job, $1,500-$3,600 depending on the unit and the site. Every quote is written before we start, and it includes labor, parts, and any disposal of the old unit. Call (940) 412-7340 for a free estimate, and you’ll know the full price before a single bolt is turned.
We Also Serve Cities Near Lantana
Beyond Lantana itself, our technicians cover Electric Gate Repair calls in Jacksonville, Miami, Tampa, and Orlando. The same Kingswell Guarantee applies on every job in every city, and our Electric Gate Repair in Lantana team coordinates scheduling with our South Florida dispatch office so you’re always talking to a live person.
Serving Lantana, FL - Our Local Coverage Area
We’re based in the Lantana area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Lantana
Most gate operators have a manual release handle, usually a small lever or pull chain on the operator itself that disengages the motor so you can push the gate by hand. On LiftMaster and DoorKing units, the release is often a keyed handle or a pull knob near the top of the motor housing. Never force a gate that’s still engaged to the motor, because you can strip the gears or bend the drive arm. If you can’t locate the release or the gate still won’t move after disengaging it, call us at (940) 412-7340 and we’ll talk you through it.
Because Lantana sits directly on the Lake Worth Lagoon, and the salt-laden onshore winds from the Intracoastal reach nearly every street in this one-square-mile town. That marine air deposits chloride on circuit boards, connectors, and drive gears year-round, and a typical residential operator here can show terminal corrosion in 5-7 years. Inland Orlando gets none of that salt exposure, so the same unit lasts two to three times as long. The answer for Lantana is marine-grade sealing and periodic inspection, which we include in our recommendation after any repair.
The panel is rarely the root cause. In Lantana, sagging swing gates are almost always a hinge-post problem: the post has bent from wind load, or the footing has loosened in saturated, sandy coastal soil, so the post can’t hold the gate plumb. We remove and reset or replace the post, correct the hinge alignment, and only then address the panel. If a previous repair only adjusted the panel, the sag will return, because the foundation under the post never got fixed. We got a call from a homeowner on Hypoluxo Island about exactly this: a LiftMaster swing gate stopped mid-cycle after a storm, and the operator housing was full of standing water. The board terminals were green with corrosion. After drying and treating the board, we replaced the rusted hinges, corrected the sag at the hinge post, and reset the safety photocell so the gate reversed on contact. We also walked the owner through the manual-release procedure so they could open the gate safely during the next power cut.
Yes. Any automatic gate in Florida must have working entrapment protection, which means photo-eyes or contact edges that stop and reverse the gate when something is in the way. This is a UL 325 federal safety requirement, not a local courtesy, and it applies to residential and commercial gates alike. If your gate closes on a car or a person and doesn’t reverse, the entrapment protection has failed, and that’s a same-day repair we prioritize. We’ll test the photo-eyes and contact edges on every visit, and we’ll document the results in writing.
If the operator housing stayed dry and the gate still cycles, even roughly, the unit is usually repairable: a new board, new limit switches, or a hinge adjustment fixes most storm damage in the $185-$520 range. If the housing flooded, the board shows heavy corrosion, or the drive gears are stripped from the gate being forced during high winds, replacement is often the honest call, and in Lantana that typically runs $350-$700 for a residential operator or $1,500-$3,600 for commercial. Either way, you’ll get the full price in writing before we start, and we won’t sell you a replacement when a repair will hold. Call (940) 412-7340 and we’ll inspect the gate at your property and give you a straight answer.
Written by Dean Prescott, Owner at Portcullis Gate Repair, serving Lantana and surrounding communities.