Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Electric Gate Repair Across Rendon
Electric gate repair in Rendon usually comes down to a power or post problem hiding behind an operator symptom. Most homes here sit on 1 to 5 acre lots with aftermarket operators bolted onto gates that were never built for automation. The result is a repair call that often starts with a stalled motor and ends with us finding an extension cord or a heaving post. If your gate won’t open, call (940) 412-7340 and we’ll diagnose it from the driveway, not a call center.
Our Electric Gate Repair crews know Rendon’s roads, the black clay under them, and the 90s-era gate hardware that’s finally wearing out all at once. Portcullis Gate Repair has been a Kingswell company since 2008, and every job starts with a written price before any work starts.
Why Portcullis Gate Repair Is Rendon’s Preferred Electric Gate Repair Company
Rendon homeowners tend to call us after dealing with another gate company that quoted low, showed up late, or fixed the symptom and ignored the cause. What changes their mind is the Kingswell Guarantee: a written price, a real arrival window, a clean job site, and a written guarantee on every repair. That guarantee runs 365 days. If the repair fails inside that window, we return and correct it at no charge. It’s stamped on the invoice, not mumbled on the way out of the driveway.
Dean Prescott, who runs our local team, has seen enough Rendon acreage gates to know that a dragging gate on Rendon-Crowley Road is rarely just a hinge issue. It’s usually the Tarrant County shrink-swell clay doing what it does. We’re a live-answer company too. Call at midnight with a gate stuck open and a horse loose, and a person picks up, not a voicemail tree.
Electric Gate Motor in Rendon
An Electric Gate Motor in Rendon – the actuator or operator that physically moves the gate – takes the hardest beating of any component on your system. These motors sit outdoors through 100°F summer afternoons, winter freezes, and the constant heaving of black clay soil under the posts they’re anchored to. When the motor starts stalling mid-travel or humming without moving, homeowners often assume the motor itself is dead. Sometimes it is. More often, the motor is fighting a misaligned gate caused by post movement, and replacing the motor without fixing the post just burns out the next one.
A typical gate motor replacement in Rendon runs $450 to $1,100 parts and labor, depending on whether you have a light-duty residential swing operator or a heavy slide-gate motor. Service calls to diagnose a motor issue start around $89 to $129, and that diagnosis fee is credited toward the repair if we do the work.
Retrofitted Operators on Original Gates
Rendon’s operators were mostly added years after the original build. A 1998 ranch house off Rendon-Crowley Road with a pipe-panel driveway gate didn’t have a LiftMaster pre-wired at construction. Someone bolted a Ghost Controls or Apollo unit on later. That means no buried conduit, no dedicated circuit, and a motor working harder than it was designed to because the post it’s mounted on was never reinforced for automation. We see this pattern constantly.
When Replacement Beats Another Repair
If your motor is 15 to 20 years old – which describes a large share of the mid-2000s operator wave in Rendon – spending $300 to fix it may not be smart money. A new actuator with a fresh control board and a proper power feed usually costs less over three years than patching an aging unit repeatedly. We’ll give you the straight comparison in writing and let you decide.
Gate Access Control in Rendon
Gate Access Control in Rendon covers everything that tells the operator when to open: keypads, remotes, intercoms, loop detectors buried in the driveway, and the phone apps that open the gate from the house. When the access system misbehaves, the gate either won’t respond at all, opens randomly, or refuses to close because a sensor reads something that isn’t there. On acreage properties with horses, that last problem is more than an annoyance.
Keypad replacement or reprogramming in Rendon typically runs $150 to $350. Adding a remote transmitter or receiver runs $80 to $200 per unit. A full access control upgrade – new keypad, two remotes, and a wired or wireless intercom – lands between $600 and $1,400 installed. Loop detector diagnosis and repair usually runs $250 to $500.
Keypad and Remote Diagnostics
Before assuming a keypad is dead, check the simplest thing: is it getting power? On Rendon acreage properties, keypads are often wired on the same undersized circuit as the operator, and a tripped breaker or a chewed wire (raccoons are brutal on low voltage) is the real culprit. We diagnose that without replacing parts you don’t need.
Opening the Gate From the House
Many Rendon homeowners want to open the gate from the kitchen or the barn without carrying a remote. That’s usually a phone-app bridge tied to your existing operator, or a wired intercom station at the house. The cost ranges from $350 for a basic app bridge to $900+ for a mounted video intercom. We’ll match the option to your operator brand rather than selling you a system that fights the existing hardware.
Trusted Brands We Service in Rendon
Our techs carry parts and repair experience for the brands most common on Rendon acreage: Ghost Controls, Viking, DoorKing, Elite, plus LiftMaster, FAAC, BFT, Linear, and Mighty Mule. Because we service nine major operator brands, the tech who pulls into your driveway already knows the specific system mounted on your gate post. We stock common boards, arms, and remotes for Ghost Controls and Viking units specifically because those names dominate the mid-2000s retrofits out here. That’s the difference between a two-visit repair and a same-visit fix.
Common Electric Gate Repair Problems We See in Rendon Homes
- Extension-cord power feeds. A surprising number of Rendon gate operators still run off an orange extension cord to the barn or a shallow trench with no conduit. These fail in wet clay, trip breakers, and can create real fire risk. We always flag them and quote a proper dedicated circuit.
- Heaving black-clay posts. Tarrant County’s shrink-swell clay moves fence and gate posts seasonally. Latch points drift, the operator arm fights the misalignment, and the control board eventually cooks. Post re-set and sag correction runs $300 to $700 depending on post condition.
- Cooked control boards from misalignment. A gate that binds at the latch forces the motor to draw excess current every cycle. The board overheats and fails. Replacing the board without fixing the post movement just means you’ll replace the board again. Board replacement runs $250 to $600.
- Mid-2000s operator failures happening in waves. The Ghost Controls and Apollo units installed during Rendon’s acreage build boom are now 15 to 20 years old. We’re replacing motors and control boards in clusters along the same rural subdivisions because the hardware was installed within the same few years and it’s all reaching end of life together.
Pricing for Electric Gate Repair in Rendon, TX
Electric gate repair in Rendon typically falls between $150 for a minor fix like a stuck safety sensor or keypad reprogram, and $1,400 for a complete operator replacement with new access control hardware. A diagnostic service call runs $89 to $129, credited toward the repair. Motor and actuator swaps run $450 to $1,100. Control board replacement runs $250 to $600. Hinge post re-set and sag correction runs $300 to $700. Every quote is written and agreed before we touch a bolt. Call (940) 412-7340 for a free estimate – we’ll give you a real dollar range on the phone, not a “technician will assess” dodge.
We Also Serve Cities Near Rendon
Our Electric Gate Repair in Rendon crews also cover nearby communities including Houston, San Antonio, Dallas, and Fort Worth. If your property sits outside Rendon proper but still in the greater metro area, call (940) 412-7340 and we’ll confirm coverage and a same-week window.
Serving Rendon, TX - Our Local Coverage Area
We’re based in the Rendon area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Rendon
It’s almost always an undersized or improperly buried power feed. Builder crews on Rendon acreage homes often ran the gate off a shared circuit with the barn or an outdoor outlet, sometimes through shallow conduit that shifted and cracked in the black clay. As the operator ages and draws more startup current, it trips the breaker. We’ll trace the circuit, replace the feed with a properly sized dedicated line, and put it in writing before any trenching. Call (940) 412-7340 for an exact diagnosis.
Yes. We retrofit manual swing and slide gates all the time out here. The catch is that most manual gates on Rendon acreage were never built with automation in mind – posts might not be reinforced, and there’s usually no power at the gate. That means the quote often includes post reinforcement, a new operator arm, and a dedicated conduit-run circuit rather than just bolting on a motor. A full manual-to-automatic retrofit typically runs $1,800 to $4,200 depending on gate size, post condition, and power distance. The quote covers everything, including the power run and safety edges.
The freeze exposed a weak point in Rendon’s exposed gate systems: battery backups and hydraulic operators that weren’t winterized failed overnight. Winterizing means testing the battery, checking the trickle charger, sealing any housing gaps where moisture can get in, and confirming the system’s cold-weather current draw is within spec. We do a winterization service call for $129 to $200 and we’ll tell you if your backup battery actually needs replacing before you spend on one.
Your post is moving. On Rendon’s black clay, hinge posts heave and settle with every rain cycle, and a replaced operator on a moving post just wears out the next motor faster. The fix is post re-set and sag correction – we lift the gate, re-level the frame, and re-anchor the hinge post so the operator isn’t fighting the geometry. That repair runs $300 to $700 and it’s the only way to stop the cycle of motor failures. Call (940) 412-7340 and we’ll quote it before any work starts.
Yes. Phone-app bridges tie into your existing operator and let you open the gate from a smartphone anywhere you have signal – that’s $350 to $600 installed. A wired video intercom from the house to the gate runs $600 to $900+ and gives you a screen, camera, and button without needing a remote. For vehicles, a loop detector buried in the driveway opens the gate automatically when a car rolls over it. We’ll match the option to your operator brand.
Written by Dean Prescott, Owner at Portcullis Gate Repair, serving Rendon since 2008.