Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Highlands, TX
Gate repair in Highlands, TX isn’t the same job it is twenty miles inland. The air itself works against your gate here. Homes sit downwind of the Ship Channel’s refinery corridor, and between that sulfur-heavy air, Gulf humidity, and the San Jacinto floodplain, gates corrode, seize, and short out faster than anywhere else in Harris County. If your swing gate drags, your slide gate grinds, or your opener died after the last high water, call Portcullis Gate Repair at (940) 412-7340. We’ll quote the job in writing before we touch a bolt.
Why Highlands Homes Are Different
Highlands is an older, unincorporated Harris County community of mid-century ranch homes on generous lots. Many properties along the caliche and gravel drives off E Wallisville Road and near Highland Woods still use manual or automatic entry gates, often on wheeled slide tracks or heavy steel swing posts that have been in the ground since the Eisenhower years. That’s not a problem by itself. What changes the work is what the local environment does to that hardware.
Airborne sulfur compounds from the petrochemical corridor settle on every exposed steel surface. They accelerate rust on hinges, weld joints, and operator enclosures at a rate that surprises homeowners from drier, cleaner-air markets. Add repeated San Jacinto River flood events, including the Harvey inundation that put much of this community underwater, and you get a specific kind of damage: silt packed into slide-gate bottom tracks, corroded limit switches, and control boards that short out months after the water recedes. A gate that survived decades somewhere else may need meaningful repair here after five or six years. That’s the reality we plan for, and it’s why we don’t quote Highlands jobs off a generic price sheet.
Our Main Highlands Services
These are the three jobs Highlands homeowners call us about most, and each has its own dedicated page so you can get a deeper look before you pick up the phone.
Gate Repair in Highlands
Most repair calls in Highlands come down to two things: corrosion or flood silt. We see swing gates that no longer close square because the hinge posts have shifted in soft, flood-saturated ground, and slide gates so packed with San Jacinto silt the wheels won’t turn. We replace bent tracks, swap rusted hinges, weld cracked joints, and get the gate moving manually again. When you’re ready to understand exactly what’s wrong and what it costs to fix, start with Gate Repair in Highlands.
Gate Installation in Highlands
New gate work in Highlands means choosing hardware rated for salt air and flood exposure. We build welded steel or aluminum gates on properly concreted posts, set to swing or slide depending on your drive’s grade and width. Long rural drives on acreage lots often call for slide gates, while modest ranch-house setbacks usually favor swing. Every installation includes a written price before fabrication begins. For details on materials, sizing, and the process, see Gate Installation in Highlands.
Electric Gate Repair in Highlands
Automatic operators in Highlands fail in patterns we don’t see inland: control boards corroded from wet, briny air, motors seized after submersion in the 2017 flood, photo-eye sensors clouded by chemical film. We service the main brands and replace actuators, arms, boards, and loops without asking you to scrap the whole system. For a detailed look at operator diagnostics and emergency response, visit Electric Gate Repair in Highlands.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Highlands
Our techs work on Viking, Ghost Controls, and DoorKing operators most weeks in Highlands, and we keep common boards, actuators, and safety-edge components on the truck or one day out. When a repair needs a part for a less common brand, we’ll tell you timing before you commit. See our brands for the full list.
Pricing for Gate Company in Highlands, TX
Every price below includes parts and labor and is quoted in writing before work starts. These are real ranges for Highlands conditions, not national averages.
| Service | Typical range in Highlands |
|---|---|
| Service call fee (waived with repair) | $60-$90 |
| Gate won’t open or close – diagnostic | $50-$100 |
| Swing gate hinge replacement | $150-$400 per hinge |
| Slide gate track cleaning and wheel replacement | $200-$550 |
| Weld repair on steel gate frame | $150-$500 per section |
| Automatic opener circuit board replacement | $250-$650 |
| Operator actuator arm replacement | $350-$850 |
| Photo-eye sensor replacement or realignment | $150-$400 |
| New safety edges on slide gate | $200-$450 |
| Full swing gate (steel, single) installed | $2,500-$6,000 |
| Full slide gate (steel, single) installed | $3,500-$8,500 |
| Complete operator replacement (motor, arm, board) | $900-$2,500 |
What pushes the number toward the top of a range in Highlands is almost always flood damage: silt packed into tracks, water inside the operator housing, or wiring that needs replacement because it sat submerged. We’ll show you what we found and what it costs before any work starts, so there’s no surprise at the end.
Neighborhoods We Serve in Highlands
We cover all of Highlands and the adjacent unincorporated pockets, from the older streets near the San Jacinto River up through the acreage lots toward the Crosby side.
- Highland Woods
- Sylvan Beach area
- E Wallisville Road corridor
- San Jacinto River floodplain properties
- East Highlands acreage lots
Response is typically same day or next morning for gate repair calls in Highlands, including weekend emergency service.
Service Area – Cities Near Highlands
Portcullis Gate Repair serves Highlands and the surrounding Harris County communities. If you’re in Channelview, TX, Baytown, TX, La Porte, TX, or Deer Park, TX, the same written-price guarantee and 365-day repair warranty apply.
Serving Highlands, TX - Our Local Coverage Area
We’re based in the Highlands area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Highlands
For gate repairs that leave a driveway open or a property unsecured, we typically reach Highlands homes the same day or the following morning, including weekends. We give you a real arrival window and a technician who shows up in uniform.
Most gate repairs and replacements in unincorporated Highlands don’t require a county permit, though larger new installations with long electrical runs may. We’ll tell you if your job needs one and handle the paperwork if it does.
No, the assessment and written quote are free. Flood damage often takes more labor, and you’ll see that in the written price before we begin. If flood silt or water damage is the cause, we’ll explain what’s salvageable and what isn’t.
Call (940) 412-7340 for a free estimate, or ask us anything about your gate. A live person answers, and your price comes in writing before any work starts.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Highlands Customers Say
"Gate wouldn't respond to the remote or the keypad. Turned out to be the control board. They had the part and swapped it the same visit. Quoted it first, no surprises."
- Everett Shaw"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike"Installed a new gate for us after the old wooden one rotted out. Clean work, showed up on time both days, and the written price didn't change. It swings perfectly."
- Donna Kirkpatrick