Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Inglewood, CA
Gate repair in Inglewood usually falls into two camps: restoring ornamental wrought iron that’s been standing since the 1950s, or fixing newer automated gates installed quickly during the SoFi Stadium-era renovation wave. Both show up on our schedule every week. The marine layer off the Pacific, only a few miles west, keeps salt-laden moisture on metal hardware year-round, so hinge seizures and rust scaling here move faster than in neighborhoods further inland. If your gate is sticking, sagging, or the opener has stopped responding, call (940) 412-7340 and we’ll give you a straight answer and a written price.
Why Inglewood Homes Are Different
Most of Inglewood’s housing stock is post-WWII bungalows and ranch homes built between the 1940s and 1960s, and the gates that came with them are now 50 to 70 years old. We routinely see deep rust pitting at ground-level welds, hinge pins that have collapsed from decades of weight, and frames that have racked out of square as the clay-heavy soil shifted underneath the posts.
The SoFi Stadium and Hollywood Park development changed the market quickly. Long-tenured homeowners are finally restoring those original wrought iron gates on stucco pillar entries, while flippers and new buyers are installing automated sliding and swing gates to match the neighborhood’s rising expectations. A lot of that newer hardware is budget-grade, and it fails fast. We get the repeat calls: actuators that burned out in under a year, sensors knocked out of alignment, slide gates that bind because the track was never right to begin with. The work here splits between preservation and correction, sometimes on the same block.
The coastal microclimate is the quiet variable. Inglewood sits three to four miles from the ocean, and the near-daily marine layer means unpainted iron develops heavy oxidation scaling in a few years, not the decade it might take in the Valley or the Inland Empire.
Our Main Inglewood Services
Inglewood homeowners call us most about two things: gates that no longer open or close properly, and gates that were installed wrong or never automated at all. Each service has its own page with pricing, timelines, and what to expect.
Gate Repair in Inglewood
A sagging gate on a 60-year-old post is as common here as morning fog. We rebuild hinge points, square out racked frames, and replace rotted or rusted sections without pretending the rest of the gate is fine. Older Inglewood gates often hide damage where the frame meets the ground: you can’t see it until the gate comes off the hinges. We quote the full repair in writing before any work begins. For a complete look at what repairs run and how we approach them, see Gate Repair in Inglewood.
Gate Installation in Inglewood
New gates in Inglewood need to match the house, not fight it. A modern welded-steel sliding gate in front of a 1950s bungalow can look wrong the day it’s installed. We help choose materials and automation that fit the home’s age and the neighborhood’s rhythm. We also handle the less glamorous part: proper posts, proper track, proper drainage. A gate installed on a shifting post is a repair waiting to happen. See Gate Installation in Inglewood for materials, options, and a measured written quote.
Electric Gate Repair in Inglewood
Electric gate problems in Inglewood usually trace back to two things: salt air attacking the circuit boards and limit switches, or opener motors that were undersized for the gate they’re driving. We diagnose the operator first, then the wiring, then the mechanical load. On commercial sliding gates along the Arbor Vitae corridor, stripped rack-and-pinion drives and worn V-groove wheels are the dominant failure. On residential swing gates, it’s more often a blown capacitor or a sensor that won’t hold alignment. Electric Gate Repair in Inglewood covers diagnosis and repair costs in detail.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Inglewood
Our techs train on the operators we meet most often in Inglewood: FAAC, BFT, Linear, and Viking, plus five other major brands. Common boards, capacitors, remote receivers, and safety edges are stocked on the truck so a first-trip fix is the norm, not the exception. Full coverage list on our brands page.
Pricing for Gate Company in Inglewood, CA
| Service | Typical range in Inglewood |
|---|---|
| Swing-gate actuator swap | $750 - $1,600 parts and labor |
| Slide-gate motor replacement | $850 - $1,900 parts and labor |
| Hinge rebuild (wrought iron, welded) | $280 - $650 per pair |
| Frame re-square and weld repair | $300 - $800 |
| Rust scaling removal and repaint prep | $250 - $700 |
| V-groove wheel replacement (commercial slide gate) | $400 - $1,100 |
| Control board replacement | $350 - $900 |
| Safety sensor alignment or replacement | $150 - $450 |
| Remote receiver replacement | $175 - $400 |
| Full gate installation (standard single driveway gate) | $2,500 - $6,500 |
Rusted bottom rails and collapsed hinge pins are the two big cost drivers on older Inglewood gates, because they mean fabrication time, not just part swaps. Whatever the number, you see it in writing before we turn a single bolt, and that written price is the price.
Neighborhoods We Serve in Inglewood
Our crews work across Inglewood daily, from the historic downtown core to the commercial strips near the stadium and the residential blocks east toward the 405.
- North Inglewood
- Morningside Park
- Downtown Inglewood
- Hollypark
- Century Heights
Most residential calls in Inglewood get a technician on site within one to two hours once dispatch confirms the job. The closer to Arbor Vitae or La Cienega you are, the faster we typically arrive.
Service Area – Cities Near Inglewood
Beyond Inglewood, we also cover the neighboring cities where homeowners face the same coastal air and aging housing stock: Hawthorne, CA, Culver City, CA, El Segundo, CA, and Lawndale, CA. Scheduling is coordinated from the brand’s Los Angeles office; crews serve Inglewood locally.
Serving Inglewood, CA - Our Local Coverage Area
We’re based in the Inglewood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Inglewood
In most cases, yes. Residential calls in Inglewood usually get a technician on site within one to two hours of dispatch. Commercial work along Arbor Vitae or La Cienega may be scheduled next morning if the job requires a lift or specialty parts. Call (940) 412-7340 and we’ll give you a real arrival window.
For a like-for-like repair or replacing the gate on existing posts, typically no. If you’re adding a new automated driveway gate, changing the property’s frontage, or installing new concrete footings, Inglewood’s building department may require a permit. We’ll tell you what’s needed before the job starts, and the quote covers what we can handle versus what you’ll file.
Every repair carries the 365-Day Done Right Promise, written on your invoice. If the repair fails inside that year, we come back and fix it at no charge. That’s the Kingswell Guarantee: written price before work, real arrival window, clean job site, and a written guarantee on the repair.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Inglewood Customers Say
"Our driveway gate stopped halfway and wouldn't close, which is a problem when it's the only thing between the street and the yard. They came out same day, replaced the motor, and it's smooth again."
- Leonard Pace"Gate wouldn't respond to the remote or the keypad. Turned out to be the control board. They had the part and swapped it the same visit. Quoted it first, no surprises."
- Everett Shaw"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike