Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Kent, WA
Gate repair in Kent, WA spans two very different worlds. The residential work looks like warped wood privacy gates on 1960s ranch homes and sagging iron drive gates on East Hill, while the commercial side centers on the Green River Valley’s warehouse corridor along SR-167, where hundreds of automated slide gates cycle through opening and closing every day. We work both ends of that spectrum, and what makes Kent jobs different is the soil, the rainfall, and the sheer volume of gate traffic. If your gate is stuck, won’t close fully, or grinds against the post, call (940) 412-7340 and we’ll give you a straight answer about what’s wrong and what it’ll cost to fix.
Why Kent Homes Are Different
Kent sits on the Green River Valley floor, where roughly 38 inches of rain falls each year and the clay-heavy soil holds moisture long after the surface looks dry. That soil expands and contracts through every wet season, which means gate posts heave or settle by fractions of an inch, and those fractions eventually pull a gate out of plumb. We see ranch homes built in the 1960s and 70s where the original gate posts were set shallow in the first place, and after forty or fifty winters they’ve rotated until the gate drags across the driveway or swings open on its own.
On East Hill and around Panther Lake, the dense tract developments from the 1980s and 2000s have their own pattern: wood privacy gates shaded by mature evergreens stay damp for months, so rot moves in at the bottom rail and hinge screws lose their bite. The repair that actually holds in Kent usually means releveling the post before replacing hardware, not just bolting new hinges onto a post that’s already leaning. That’s the difference between a fix that lasts a year and one that lasts a decade.
Our Main Kent Services
The two jobs Kent homeowners call about most are a gate that won’t open or close, and a gate that’s finally beyond repair. Here’s how we handle each one in this city.
Gate Repair in Kent
Most residential gate repairs in Kent come down to the same few culprits: a post that’s shifted in the clay soil, hinges that have rusted through or torn out of the wood, or a latch that no longer lines up because the whole gate has racked. We start by finding out whether the foundation is still doing its job, because on valley-floor properties it often isn’t. Then we relevel, replace hardware, and adjust the gate so it swings clean and latches without having to be lifted or kicked. For swing gates and slide gates on older Kent homes, we quote the full repair in writing before any work starts. Full details are on our Gate Repair in Kent page.
Gate Installation in Kent
A new gate in Kent has to be built for the soil it sits in. We see too many installations where a contractor dug a two-foot hole, dropped a post in, and poured concrete around it; after two wet seasons the post leans and the gate sags. Our installations use footings deep enough to get below the shifting topsoil, and we grade the bottom of the gate for drainage so the wood doesn’t sit in standing water. We’ll quote the full project, including the post work, hardware, and gate build, before a single hole is dug. Complete information is on our Gate Installation in Kent page.
Electric Gate Repair in Kent
Electric gates in Kent fail in predictable ways. The operator, the motorized arm or box that moves the gate, burns out faster on the valley’s commercial side where gates cycle hundreds of times a day. On the residential side, moisture in the control board and limit switches knocked out of adjustment by a shifting gate are more typical. We service LiftMaster, FAAC, Viking, Ghost Controls, and the other major brands, and we diagnose before we quote, so you know the price before we turn a wrench. The full scope of what we fix is on our Electric Gate Repair in Kent page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Kent
Our techs work on Linear, Viking, Ghost Controls, and DoorKing operators regularly in Kent, along with five other major brands. We stock common replacement parts in our service vehicles, so many repairs happen the same visit. See the full list on our brands page.
Pricing for Gate Company in Kent, WA
| Service | Typical range in Kent |
|---|---|
| Gate repair service call and diagnosis | $75-$125 |
| Wood gate hinge replacement | $150-$350 |
| Swing gate post releveling and reset | $300-$600 per post |
| Gate latch and strike plate adjustment or replacement | $100-$250 |
| Sagging gate frame correction | $250-$500 |
| Standard wood privacy gate installation | $800-$2,500 |
| Iron or steel driveway gate installation | $1,500-$5,000 |
| Swing gate actuator replacement | $600-$1,200 |
| Slide gate motor replacement | $800-$1,800 |
| Control board replacement | $300-$700 |
| Photo eye or safety sensor replacement | $150-$350 |
What pushes a Kent job toward the top of those ranges is usually the post. When clay soil has shifted a post out of plumb, the repair has to include releveling before new hardware goes on, and that’s labor and time other quotes don’t always count. We quote the full price in writing before any work starts, so the number on the invoice matches the number we gave you.
Neighborhoods We Serve in Kent
We run calls across all of Kent, from the valley floor up through the hills. Our typical response window for Kent jobs is same-day or next-day depending on the call load, and we’ll always give you a real arrival window when you book, not a four-hour shrug.
- East Hill
- Panther Lake
- Valley floor along SR-167
- West Hill
- Downtown Kent and historic district
Service Area – Cities Near Kent
We also take gate repair calls in the cities around Kent. If you’re in Renton, WA, up the valley in Auburn, CA, west in Federal Way, WA, or over in Maple Valley, WA, the same written-price promise applies.
Serving Kent, WA - Our Local Coverage Area
We’re based in the Kent area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Kent
We dispatch same-day for most Kent calls when they come in before mid-afternoon, and we give you a real arrival window when you call, not an all-day range. Call (940) 412-7340 and we’ll tell you exactly when a tech will be there.
Most gate repairs and like-for-like replacements don’t require a permit in Kent, but new installations with powered operators sometimes need an electrical permit depending on the scope. We’ll tell you during the estimate whether your job needs one.
Yes. Every repair in Kent carries the 365-Day Done Right Promise in writing. If the repair fails within 365 days, we come back and fix it at no charge, no argument, no second invoice.
Contact Portcullis Gate Repair in Kent, WA
If your gate is down, stuck, or just getting harder to move every month, call (940) 412-7340. Dean Prescott and our Kent crews answer live around the clock, and every job begins with a written price you approve before any work starts. We’ll show up in the window we gave you, do the job, and hand you a written guarantee when we leave.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Kent Customers Say
"Good repair on a sagging gate and a new hinge welded on. Took them a couple days to get the part in, but they told me that up front and it's been solid since."
- Hector Villanueva"The opener gave out and we were manually pushing the gate for a week. Portcullis got us in quick, swapped the opener, and set up the remotes for both our cars. Great to have it working again."
- Priscilla Nava"Our driveway gate stopped halfway and wouldn't close, which is a problem when it's the only thing between the street and the yard. They came out same day, replaced the motor, and it's smooth again."
- Leonard Pace