Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Mountain View, CA
Gate repair in Mountain View runs into a split personality that most cities don’t have: 1950s ranch homes with original iron side gates on one block, and a tech-campus slide gate with vendor credentialing on the next. The salt air off South San Francisco Bay accelerates rust on hinges and latch hardware faster than in Cupertino or Campbell, and many of the steel posts under those older gates are rotting at the base. We service all of it, residential and commercial. Call (940) 412-7340 and you’ll get a real person, a straight answer, and a written price before anything gets unbolted.
Why Mountain View Homes Are Different
Mountain View sits right against the Bay, and that changes gate work. The prevailing westerly wind pushes salt-laden marine air across the city, so uncoated iron and thin powder-coating fail faster here than nearly anywhere else in the Valley. In Rex Manor, Castro City, and Wagon Wheel, the original wrought-iron side gates from the 1950s and 60s show it: rust blooms at the hinge welds, latch bodies seize, and the post base rots out where irrigation water pools. Cuesta Park is no different. These are 50-plus-year-old gates still in daily use.
The morning fog that settles near the Bay flatlands adds a second problem. Condensation sits on gate hardware through half the year, and any scratch in the paint becomes a rust point within months. For a homeowner, that means a gate that sticks, squeals, or won’t latch by year three or four. Older chain-link rear gates have it worse: the tension bar rusts through and the fabric sags off the top rail. On the commercial side, North Bayshore has FAAC and HySecurity slide operators on campus perimeters, often behind vendor credentialing that a residential-only gate company simply doesn’t carry. We carry commercial access-control training as standard, not as an add-on.
Our Main Mountain View Services
Most Mountain View calls fall into one of three buckets: a gate that won’t open, a gate that needs replacing, or an electric operator that quit. Each has its own page below with local pricing, common failure modes, and what the repair actually involves.
Gate Repair in Mountain View
Hinges pull out of rotted posts, latch bars don’t line up anymore, and steel frames rust through where the sprinklers hit them. That’s the standard Mountain View repair call. We cut out the rot, replace or weld what’s failed, and set the gate so it swings clean and latches without a fight. On slide gates, we replace worn rollers and track. Gate Repair in Mountain View covers every failure we see, with the written Kingswell Guarantee on the invoice.
Gate Installation in Mountain View
New construction here runs two ways: a spec-grade aluminum or steel driveway gate on a ranch home, or a custom automated gate with battery backup and smartphone access on a newer build or remodel. We measure the opening, spec the hinges and frame for the soil and wind, and handle the set in concrete with proper drainage. Gate Installation in Mountain View walks through materials, permits, and what a written quote includes before we order anything.
Electric Gate Repair in Mountain View
Electric gate operators fail in predictable ways: the actuator arm strips, the control board cooks, the safety edge stops responding, or a storm knocked out a limit switch. On Mountain View’s townhome complexes along Middlefield Road, a shared driveway slide gate with a down operator blocks every resident until it’s fixed. Electric Gate Repair in Mountain View details the diagnosis process, the brand experience we carry, and the free return visit if the repair fails inside 365 days.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Mountain View
Our technicians are trained on nine major gate-operator brands, including Linear, Viking, Ghost Controls, and DoorKing; we carry common boards, remotes, and safety edges on the truck, so many Mountain View repairs finish on the first visit. See the full list on our brands page.
Pricing for Gate Company in Mountain View, CA
| Service | Typical range in Mountain View |
|---|---|
| Hinge replacement on a wrought-iron side gate (parts and labor) | $180 - $320 |
| Post replacement, including new concrete footer | $280 - $520 |
| Swing-gate actuator swap (the motorized arm that pushes the gate open) | $650 - $1,100 |
| Slide-gate roller and track replacement | $340 - $610 |
| Gate frame straightening and weld repair | $220 - $450 |
| Control board replacement on a residential operator | $280 - $540 |
| Safety edge replacement (the sensor strip that stops the gate on contact) | $180 - $330 |
| Latch and strike plate realignment | $110 - $220 |
| Keypad and receiver replacement | $160 - $310 |
| Full gate removal and new steel post set | $520 - $980 |
| Chain-link fabric and tension bar replacement (rear gates) | $240 - $410 |
| Commercial slide-gate operator diagnostic (North Bayshore/tech campus) | $180 - $380 |
Prices here run at the higher end when rust has reached the post base and we’re cutting out concrete, and on commercial work where vendor credentialing and facilities coordination add a step. You’ll get the price in writing before any work starts; that’s a Kingswell Guarantee, not a courtesy.
Neighborhoods We Serve in Mountain View
We cover the whole city, from Rex Manor and Castro City to Wagon Wheel and Cuesta Park, plus the denser townhome corridors along Middlefield Road and Castro Street and the commercial perimeters in North Bayshore.
- Rex Manor
- Castro City
- Wagon Wheel
- Cuesta Park
- North Bayshore
- Blossom Valley
We typically reach Mountain View addresses same day for repairs; installations and new-operator quotes are scheduled with a measured, written price.
Service Area – Cities Near Mountain View
Beyond Mountain View itself, we cover Los Altos, CA, Stanford, CA, and Cupertino, CA directly. For clients near the Texas operation, our sister location in Sunnyvale, TX serves that market. Scheduling for all Bay Area work runs through our Bay Area office, with local crews dispatched to Mountain View all week.
Serving Mountain View, CA - Our Local Coverage Area
We’re based in the Mountain View area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Mountain View
For gate repairs, most Mountain View calls get same-day service if you reach us before mid-afternoon. The marine air and bay fog create rust failures that only get worse while the gate sits half-open, so we prioritize calls where the gate can’t close or won’t open. Call (940) 412-7340 and we’ll give you a real arrival window, not a guess.
For repairs on an existing gate, generally no. For new installations, especially in HOA-governed townhome complexes along Middlefield or Castro, the association’s architectural committee often requires prior sign-off, and the City of Mountain View may require a permit for new automated driveway gates. We’ll flag what applies on your quote, in writing, before anything is ordered.
Yes. Mountain View’s tech campuses and the homes around them are two different jobs, but we carry the training for both: residential swing gates on ranch homes and commercial slide operators on credentialed campus perimeters. The Kingswell Guarantee, the written price, and the 365-day promise apply to every one of them.
Contact
If your gate is stuck, sagging, or dead in Mountain View, call (940) 412-7340. You’ll get a live person, an honest answer, and a written price before we turn a single bolt. That’s the Kingswell Way, and it’s been the standard on every Portcullis job since 2008.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Mountain View Customers Say
"Gate was dragging and screeching across the driveway. I figured I'd need a whole new setup. He adjusted the track and rollers and it was a fraction of what I expected. Honest work."
- Omar Haddad"Our intercom and gate motor both quit. They fixed the whole system in one visit and explained the warranty clearly. On time, polite, and tidy. Can't ask for more."
- Yvette Marchetti"Good repair on a sagging gate and a new hinge welded on. Took them a couple days to get the part in, but they told me that up front and it's been solid since."
- Hector Villanueva