Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Gate Company in Olympia Heights, FL
Gate repair in Olympia Heights usually costs $150-$400 for mechanical fixes, $300-$900 for motor and control-board work, and $1,200-$4,500 for a full new gate. What makes Olympia Heights different is the housing stock: mid-century CBS ranches with decorative wrought-iron gates mortared into masonry walls, sitting in salt air and hurricane country. We’re Portcullis Gate Repair, a Kingswell company, and we quote every job in writing before any work starts. Call (940) 412-7340 and a live person answers, day or night.
Why Olympia Heights Homes Are Different
Olympia Heights runs through western Miami-Dade, and most of the homes here are concrete block ranch houses built between the 1950s and 1970s. That shapes nearly every gate call we take. The gate posts are usually grouted directly into masonry perimeter walls, so a sagging hinge or a bent post often needs masonry patching around the anchor, not just a metal repair. We carry epoxy anchors and the right grout mixes to reset posts without chipping out more of the wall than necessary.
The bigger factor is the air. Salt from the Atlantic and humidity that rarely dips below seventy percent corrode wrought iron aggressively. Unsealed motors, exposed control boards, and bare steel hinges fail in three to five years here, not ten. And Miami-Dade’s post-Andrew wind-load codes are among the strictest in the country. Any structural replacement or permit-triggering repair has to meet high-velocity hurricane zone anchoring specs. Out-of-county contractors often install a gate that passes a visual check but not an inspection. We know the HVHZ hardware requirements, and we install to them on every swing and slide gate in Olympia Heights.
Our Main Olympia Heights Services
Most Olympia Heights homeowners call us for one of three things: a gate that won’t open, a gate that needs to be replaced, or a motor and control board that failed. Each has its own page with full pricing and detail.
Gate Repair in Olympia Heights
The most common repair we handle in Olympia Heights is a swing gate that has started dragging or a hinge that has pulled loose from a masonry post. The moisture here attacks hinge pins and post anchors alike, and original ironwork from the 1960s and 1970s often has welds that were never designed for this climate. We diagnose the full range: bent frames, cracked welds, snapped chain drives, rusted-through posts, and gate leaves that have settled out of alignment. Every repair gets a written quote first and a written guarantee after. Details on our Gate Repair in Olympia Heights page.

Gate Installation in Olympia Heights
New gates in Olympia Heights usually replace original ironwork that has finally rusted through, or they upgrade a home with a driveway gate that was never there. Because most perimeter walls are concrete block, installation means setting new steel posts into cored and epoxied holes, not just digging into soil. We match the style of the neighborhood, from simple ranch-style iron to more ornamental Cuban-influenced rejas. Every install is measured, priced in writing, and scheduled in a real arrival window. See Gate Installation in Olympia Heights for full scope and pricing.

Electric Gate Repair in Olympia Heights
Automatic gate motors in Olympia Heights live hard lives. The sealed-enclosure assumption that works in drier climates doesn’t hold here, and we regularly find corroded terminals, shorted control boards, and seized actuator arms. We service nine major operator brands, including Viking and Linear, so the technician who arrives already knows your system rather than learning it in your driveway. Motor swaps, board replacements, safety-edge rewiring, and remote programming are all done with the same written price and written guarantee. Full breakdowns and pricing are on the Electric Gate Repair in Olympia Heights page.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Olympia Heights
We maintain service certification across nine gate-operator brands, and most Olympia Heights homes run Linear, Viking, Ghost Controls, or DoorKing openers. We keep common control boards, remotes, and safety edges stocked locally so a typical motor or board swap doesn’t wait on a distributor. See our brands for the full list and what we repair.
Pricing for Gate Company in Olympia Heights, FL
What you’ll pay depends on whether we’re repairing what you have, replacing a motor, or building something new. These are the ranges we see most in Olympia Heights, including parts and labor.
| Service | Typical range in Olympia Heights |
|---|---|
| Basic gate repair (hinge, latch, alignment) | $150 - $400 |
| Gate motor replacement | $450 - $1,200 |
| Control board replacement | $300 - $900 |
| Sensor and safety-edge replacement | $250 - $650 |
| Wrought-iron weld repair | $180 - $600 |
| Masonry post repair or re-anchor | $300 - $1,000 |
| Full gate installation (single swing) | $1,200 - $2,600 |
| Full gate installation (slide) | $2,500 - $4,500 |
| Gate automation upgrade | $800 - $2,000 |
In Olympia Heights, prices push higher when a job involves masonry anchor work on a concrete block wall, HVHZ hardware for a permit-triggered replacement, or finish-matching on old decorative ironwork that has to be restored rather than swapped. Every quote here is written, agreed, and fixed before we turn a single bolt. If the repair fails within 365 days, we come back and correct it at no charge under the 365-Day Done Right Promise.
Neighborhoods We Serve in Olympia Heights
We cover all of Olympia Heights and the surrounding area, including the residential streets near Coral Way, Bird Road, and Miller Drive. Most calls get a same-day or next-day visit once the job is scheduled, and emergency calls are always answered live, around the clock.
- Olympia Heights proper
- Westwood Lakes
- University Park area
- Westchester border
- Snapper Creek area
Service Area – Cities Near Olympia Heights
Our crews work across South Florida from our Miami area dispatch. Beyond Olympia Heights, we coordinate service throughout the state with local Kingswell crews in Jacksonville, FL, Miami, FL, Tampa, FL, and Orlando, FL. If you’re near any of those cities, the same written-price standard applies.
Serving Olympia Heights, FL - Our Local Coverage Area
We’re based in the Olympia Heights area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Olympia Heights
Most Olympia Heights jobs are scheduled for same-day or next-day service once you speak with our dispatch team. Emergency calls are handled around the clock by a live person, not a voicemail tree. Call (940) 412-7340 and we’ll give you a real arrival window, not a four-hour guess.
Yes. Any structural replacement or anchoring work that triggers a permit in Miami-Dade must meet high-velocity hurricane zone specs, and we install to that standard on every job. We know which hardware and anchoring methods pass inspection, and we include that in the written quote.
Always. In Olympia Heights and everywhere we operate, you get a written price before any work begins. If the repair fails within the 365-day guarantee period, the return visit is free. Call (940) 412-7340 for a free estimate.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Olympia Heights Customers Say
"Gate was dragging and screeching across the driveway. I figured I'd need a whole new setup. He adjusted the track and rollers and it was a fraction of what I expected. Honest work."
- Omar Haddad"Our intercom and gate motor both quit. They fixed the whole system in one visit and explained the warranty clearly. On time, polite, and tidy. Can't ask for more."
- Yvette Marchetti"Good repair on a sagging gate and a new hinge welded on. Took them a couple days to get the part in, but they told me that up front and it's been solid since."
- Hector Villanueva





Before
After
Before
After
Before
After