Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Webster, TX
Gate repair in Webster means dealing with two forces most Houston suburbs only read about: salt air from Galveston Bay and standing water from Clear Creek. We’re Portcullis Gate Repair, an independently owned Kingswell company, and we work on the swing gates, slide gates, and electric operators that protect Webster’s 1970s-to-1990s subdivisions and the commercial properties along NASA Road 1. Our Webster crews stock the parts that fail here most: submerged control boards, corroded actuators, and rusted hinge hardware. If your gate won’t open or won’t close, call (940) 412-7340 and a live person will answer.
Why Webster Homes Are Different
Most of Webster’s residential subdivisions were built in the 1970s through 1990s to house the NASA/JSC workforce. That means a large number of neighborhood-entry swing and slide gates now run on operators that are 30 to 40 years old. The OEM parts for those systems are getting hard to source, and the original control boards were never designed for this environment anyway. Webster sits in the Clear Creek flood corridor a few miles from Galveston Bay, and during Harvey, large sections of the Clear Lake area took on water at gate-motor height. A soaked 1990s-era FAAC or Linear operator almost never recovers once silt gets inside the housing. So in Webster, gate work is very often a motor or board replacement, not an adjustment. Add the salt-laden Gulf air that accelerates rust on iron frames and corrodes electrical contacts inside operators faster than inland Houston, and you get a repair profile that’s genuinely different from Pearland or Friendswood.
Commercial properties along Bay Area Boulevard and NASA Road 1 add another layer. Aerospace contractor facilities run heavy-duty access-control gates through high daily cycle counts, so mechanical wear shows up earlier than it would on a residential gate. Whether it’s a ranch-style home in a 1980s subdivision or a contractor’s slide gate, the failure pattern is usually the same: water or corrosion got there first.
Our Main Webster Services
Webster homeowners call us most often for two things: a gate that stopped moving, and a gate that needs to be replaced entirely. Each service has its own page where you’ll find full pricing, timelines, and what to expect.
Gate Repair in Webster
When a Webster gate fails, it’s usually the operator, the control board, or the hinge hardware that gave out. We repair all of it. Because so many local operators sit low to the ground in flood-prone subdivisions near Clear Creek and Mud Lake, we almost always start by checking whether water has reached the motor housing or the board. Gate Repair in Webster covers common failures, what we can fix same-day, and what a typical swing-gate actuator swap runs in this area.
Gate Installation in Webster
A new gate in Webster needs to be specified for salt air and occasional standing water. That means powder-coated steel or aluminum frames, sealed control boxes, and operators mounted where floodwater can’t reach them as easily. We measure, order, and install the full system, from the post footings to the operator and the safety edges. Gate Installation in Webster walks through what a full installation includes and what drives the cost in Webster specifically.
Electric Gate Repair in Webster
Electric gate problems in Webster often trace back to the operator: the motorized arm or gearbox that pushes the gate open. But we also see keypads that short out after a storm, loop detectors that stop sensing vehicles, and wiring that corrodes faster near the Bay. Electric Gate Repair in Webster explains how we diagnose an operator that hums but doesn’t move, and what board replacement typically costs on a Webster flood-damaged unit, plus how our 365-Day Done Right Promise applies to electric work.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Webster
Our Webster techs carry parts for FAAC, BFT, Linear, and Viking operators, which covers most of what’s installed in the Clear Lake area. If your system runs something less common, we can usually source the board or actuator within a few days. See our brands for the full list of nine operators we’re factory-trained on.
Pricing for Gate Company in Webster, TX
| Service | Typical range in Webster |
|---|---|
| Swing-gate actuator swap (parts and labor) | $650-$1,400 |
| Control board replacement | $400-$950 |
| Hinge and bracket repair or replacement | $300-$700 |
| Weld repair on iron or steel gate frame | $250-$600 |
| Keypad or intercom replacement | $350-$900 |
| Loop detector replacement or tuning | $300-$650 |
| Photo-eye or safety-sensor replacement | $250-$450 |
| Slide-gate roller and track repair | $400-$900 |
| Full operator replacement (residential) | $1,200-$2,800 |
Water damage pushes prices up in Webster. A board that’s been fully submerged in silty floodwater usually needs replacement rather than repair, and corroded housings sometimes require fabrication work. Whatever the job, you get a written price before any work starts, and that price doesn’t change at the door.
Neighborhoods We Serve in Webster
Our Webster crews work all over the city, from the older subdivisions near Clear Creek to the commercial corridors along NASA Road 1 and Bay Area Boulevard. We schedule by neighborhood each day, and most Webster repair calls get a same-day or next-day window.
- Brookwood
- Edgewater
- Heritage Park
- Oakbrook
- Westbrook
Service Area – Cities Near Webster
Webster sits at the center of the Bay Area, and we run calls into the neighboring communities every week. If your gate is down in Friendswood, TX, League City, TX, Seabrook, TX, or Pearland, TX, the same Kingswell Guarantee applies: written price, real arrival window, clean job site, and a written guarantee on the repair.
Serving Webster, TX - Our Local Coverage Area
We’re based in the Webster area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Webster
Most Webster repair calls get a same-day or next-day arrival window. If your gate is stuck open and the property is unsecured, tell the person who answers and we’ll prioritize the call. You’ll get a real arrival window, not a four-hour spread.
Some Webster subdivisions with neighborhood-entry gates require HOA approval before a full operator or gate replacement. We’ll let you know what’s needed and can often provide the spec sheet or quote the HOA wants. The repair itself is usually exempt from approval.
If a repair we made fails within 365 days, we return and fix it at no charge. That’s written on your invoice. For homes in Webster’s lowest-lying areas, we may also recommend mounting the next operator or board higher than the original to reduce future exposure.
If your gate is down in Webster, call (940) 412-7340 now. A live person answers, gives you a written price before any work starts, and stands behind the repair with the 365-Day Done Right Promise.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Webster Customers Say
"Gate wouldn't respond to the remote or the keypad. Turned out to be the control board. They had the part and swapped it the same visit. Quoted it first, no surprises."
- Everett Shaw"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike"Installed a new gate for us after the old wooden one rotted out. Clean work, showed up on time both days, and the written price didn't change. It swings perfectly."
- Donna Kirkpatrick