Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Austin, TX
Gate repair in Austin means working with two different cities on either side of I-35. East of the highway, Blackland Prairie clay swells and shrinks with every wet-dry cycle, racking gate posts out of alignment and throwing operators off their limit settings. West of it, caliche and limestone demand a hammer drill and sleeve anchors for any post that’s going to stay plumb. We’re Portcullis Gate Repair, and whether you need a swing gate rebuilt, a slide gate operator replaced, or a full new installation, we quote the price in writing before any work starts. Call (940) 412-7340 and a live person answers, day or night.
Why Austin Homes Are Different
Austin’s housing stock splits along the same fault line as its soil. Older central neighborhoods like Hyde Park, Bouldin, and Travis Heights hold tight lots with 1940s-1970s bungalows whose wood and wrought-iron privacy gates have weathered forty or fifty Texas summers. Those jobs are usually about rusted hinges, sagging frame corners, and latch hardware that no longer lines up. Out on the ring, the story changes: Steiner Ranch, Avery Ranch, Circle C Ranch, and Falconhead went up in the 2000s and 2010s with automated slide and swing gates as standard HOA features, and those operators are now reaching end-of-life in clusters. A technician working that corridor sees the same failed control board and tired motor two, three times a week.
Then there’s the weather. Austin cycles between 100-degree-plus summer heat that bakes control boards inside their enclosures and sudden hard freezes like February 2021’s Winter Storm Uri, which drove temperatures into single digits and destroyed motors, weld seams, and boards across the metro. Many Uri-era repairs were rushed to get gates working again. A lot of them are failing now, and we’re seeing the second wave of those service calls daily.
Our Main Austin Services
Most Austin homeowners call us about one of three things: a gate that won’t open or close properly, a brand-new gate they want installed correctly the first time, or an electric operator that’s stopped responding. Each has its own dedicated page here.
Gate Repair in Austin
Gate repair in Austin usually means one of three failure patterns: posts racked out of alignment by expanding clay east of I-35, hinge and weld fatigue on older central-Austin gates, or operator faults on 2000s-era HOA installations. In far northwest Austin around Avery Ranch and Pearson Place, we regularly find posts poured shallow into caliche because the original installer hit refusal a foot down, assumed it was bedrock, and skipped the sleeve anchors. The post has been tilting ever since. Our techs diagnose that pattern before they leave the truck. Full details are on our Gate Repair in Austin page.
Gate Installation in Austin
A new gate in Austin lives or dies by its posts. West-of-I-35 caliche means drilling and anchoring into rock; east-of-I-35 clay means deep footings that won’t shift with the seasons. HOA communities like Steiner Ranch and Circle C also have design review requirements that can hold up a project if the paperwork isn’t right. We handle the concrete, the hardware, and the alignment, and we put the full price in writing before the first post hole goes in. See the process on our Gate Installation in Austin page.
Electric Gate Repair in Austin
Electric gate repair in Austin often comes down to the control board. Austin’s heat cooks electronics inside their enclosures, and the freeze-thaw cycle after Uri killed a generation of boards that got patched rather than replaced. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule systems, and our techs arrive already knowing the operator on your property. A written diagnosis with a fixed price comes before any replacement part goes in. Read the specifics on our Electric Gate Repair in Austin page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Austin
Our Austin crews carry boards, arms, remote receivers, and safety-edge hardware for FAAC, BFT, Linear, Viking, and five other major operator brands. Most common failures are diagnosed and repaired the same visit because the parts are already on the truck. See the full list on our brands page.
Pricing for Gate Company in Austin, TX
Here are the ranges we quote most often for gate work in Austin. Every price is agreed in writing before we touch a bolt.
| Service | Typical range in Austin |
|---|---|
| Standard gate repair visit & diagnosis | $95-$195 |
| Swing gate actuator swap (parts & labor) | $650-$1,450 |
| Slide gate operator replacement | $1,200-$2,600 |
| Control board replacement | $400-$950 |
| Post reset or reinforcement | $300-$800 |
| Hinge and weld repair | $250-$650 |
| Safety edge & photo-eye replacement | $200-$450 |
| Remote keypad and receiver replacement | $150-$350 |
| Full residential swing gate installation | $2,800-$6,500 |
| Full automated slide gate installation | $4,000-$12,000 |
| Automatic gate conversion (manual to electric) | $1,500-$3,500 |
What pushes a job toward the top of those ranges in Austin is usually site access: west-side caliche drilling adds labor time, and HOA-corridor properties with long runs from the house to the gate add trenching for power and safety edges. Whatever the number, it’s on the written quote before we start, and it does not change after the gate is apart.
Neighborhoods We Serve in Austin
We cover the full Austin metro, from the older central neighborhoods to the master-planned communities on the north and west edges. Typical response time for non-emergency calls is same-day or next-day depending on call volume.
- Hyde Park
- Bouldin
- Travis Heights
- Steiner Ranch
- Avery Ranch
- Circle C Ranch
- Falconhead
Service Area – Cities Near Austin
Our Austin-dispatch crews also serve the surrounding metro, including Pflugerville, TX, Cedar Park, TX, Manor, TX, and Round Rock, TX. Scheduling is coordinated from our Austin office, so you get one number and one written price no matter which side of the county you’re on.
Serving Austin, TX - Our Local Coverage Area
We’re based in the Austin area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Austin
For a gate that’s stuck open and a driveway that’s exposed, we treat it as an emergency and route the nearest available technician. Most Austin neighborhoods see same-day arrival, with the rest inside 24 hours. Call (940) 412-7340 and a live person tells you the window on the spot.
That depends on your community’s architectural review rules. Many Austin HOA communities like Steiner Ranch and Circle C Ranch require approval for a new gate or a full operator swap, but not for repairs that keep the existing footprint and design. We’ll tell you what your specific HOA typically requires before you sign anything. Call (940) 412-7340 with your community name and we’ll walk you through it.
Yes, most of our Austin repair work is on gates installed or repaired by someone else first. Shallow posts in caliche, undersized actuators, and wiring with no drip loops are the three most common things we correct. We diagnose the root cause and quote a fix in writing before any work starts. Call (940) 412-7340 to have someone put eyes on it.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Austin Customers Say
"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike"Installed a new gate for us after the old wooden one rotted out. Clean work, showed up on time both days, and the written price didn't change. It swings perfectly."
- Donna Kirkpatrick"Gate was dragging and screeching across the driveway. I figured I'd need a whole new setup. He adjusted the track and rollers and it was a fraction of what I expected. Honest work."
- Omar Haddad