Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Antioch, CA
Gate repair in Antioch means working on hardware that gets beaten by Delta wind, baked by triple-digit heat, and asked to hold up 15 to 25 years after it was installed. The late-1990s and mid-2000s buildout along Deer Valley Road, Lone Tree Way, and Sand Creek Road put thousands of ornamental iron driveway gates and pool gates into service at roughly the same time, and those systems are now failing on a compressed schedule. We’re a Kingswell company, independently owned and operated, and every job we take in Antioch starts with a written price before a single bolt gets turned. Call (940) 412-7340 to get a technician out – a live person answers around the clock.
Why Antioch Homes Are Different
Antioch sits at the eastern end of the Delta wind corridor, where afternoon westerlies funnel through the Carquinez Strait and regularly gust to 25 to 35 mph from June through September. That daily wind load does something most gate manufacturers never planned for: it pushes automatic gates past their stop points, which the sensor reads as an obstruction, which makes the motor run again and again trying to close against the breeze. We see burned-out limit switches and worn motor brushes on operators that are only months old, not years old – a problem you won’t find in Clayton or coastal towns where the air just sits still.
Add summer temperatures above 100°F and you get a flex-and-contract cycle that cracks welds and loosens post anchors faster than the spec sheets ever anticipated. Metal expands under heat, the wind loads the frame, and the repeated movement works every joint. Older blocks near downtown and the riverfront have their own issues: 1960s and 1970s wood-and-post or chain-link systems built on concrete footings that have shifted with freeze-thaw cycles and settled ground over half a century. A post that’s drifted two inches out of plumb makes every hinge fight the gate’s own weight.
Our Main Antioch Services
Most Antioch homeowners reach us for one of three things: a gate that stopped working, a gate that needs to be built, or an electric operator that’s doing something it shouldn’t. Each service has its own dedicated Antioch page with full details, local pricing, and what to expect when the truck pulls up.
Gate Repair in Antioch
Gate repair covers the mechanical side: hinges, posts, weld points, drop rods, and the frame itself. In Antioch, wind cycling is the first thing we check, because a gate that gets pushed open by a gust every afternoon endures thousands of extra stress cycles each summer. The repairs we do here often involve resetting posts that have worked loose in wind-load, re-welding joints that cracked under flex, and replacing hinge pins that wore oval-shaped from constant movement. Every repair carries the 365-Day Done Right Promise in writing. Read the full details on Gate Repair in Antioch.
Gate Installation in Antioch
New gate installations in Antioch need to be planned around the wind, not just the driveway. A gate that’s too tall for its post depth or hung with hinges too light for the sail area will lean within a season. The housing stock here runs mostly ornamental iron driveway gates and pool gates from the late-1990s and 2000s buildout, so replacement work often means matching an existing fence line and style while upgrading footings and hardware. We quote the full job in writing before anything is ordered. See the full scope on Gate Installation in Antioch.
Electric Gate Repair in Antioch
Electric gate repair in Antioch is where the Delta wind does its most frustrating work. The operator – the motorized unit that physically moves the gate – gets fed false obstruction signals when gusts push the gate past its stop point, and the motor runs extra cycles every afternoon. We check the wind-cycle motor run count before assuming electrical failure, because the fix is often a sensor adjustment plus a limit switch replacement rather than a new board. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Full details, including local pricing, are on Electric Gate Repair in Antioch.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Antioch
We carry service parts for the gate operators Antioch homes use most: Linear, Viking, Ghost Controls, and DoorKing are all in our local truck stock. That means common control boards, limit switches, and actuator arms for these brands can usually be replaced on the first visit rather than waiting on a shipment. See our brands for the full lineup.
Pricing for Gate Company in Antioch, CA
| Service | Typical range in Antioch |
|---|---|
| Swing gate actuator swap (parts and labor) | $850 - $1,400 |
| Gate operator replacement (motor unit only) | $950 - $1,700 |
| Hinge and post repair (weld or reinforcement) | $300 - $700 |
| Full ornamental iron gate installation | $2,200 - $4,800 |
| Control board replacement | $350 - $650 |
| Limit switch and sensor adjustment | $180 - $320 |
| Chain-link gate post reset (concrete footing) | $400 - $800 |
| Wood gate rebuild (new frame and pickets) | $600 - $1,200 |
| Gate operator diagnostic visit (applied to repair) | $89 - $150 |
What pushes price up in Antioch is usually wind-related damage that’s been ignored for a season: a post that’s shifted far enough that the footing needs to be re-poured, or an operator that ran so many false cycles that the motor itself is cooked. You’ll get the full written price before we start, every time, and that price doesn’t change when the job gets hard.
Neighborhoods We Serve in Antioch
We work across Antioch, and most jobs fit into a single afternoon or morning visit once the parts are confirmed on the truck. Ornamental iron gates dominate in the Deer Valley Road and Lone Tree Way corridors, while downtown and riverfront blocks lean older, with wood-frame and chain-link setups more common. These are the neighborhoods we’re in most weeks:
- Deer Valley Road corridor
- Lone Tree Way and Sand Creek Road areas
- Downtown Antioch
- Antioch riverfront and older blocks
- Black Diamond area
Service Area – Cities Near Antioch
The same written-price standard and 365-Day Done Right Promise applies in every city we cover. We regularly send technicians to Oakley, CA, Pittsburg, CA, Clayton, CA, and Brentwood, CA, with the same around-the-clock call answering and same-day emergency availability where the work permits.
Serving Antioch, CA - Our Local Coverage Area
We’re based in the Antioch area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Antioch
Most mechanical and electric repairs in Antioch are scheduled same-day or next-morning, depending on when you call and whether parts are needed. Emergency calls – a gate stuck open, a post that’s come loose – get priority. The dispatcher will give you a real arrival window, not a four-hour spread. Call (940) 412-7340 to check availability.
If your property falls under an HOA, the HOA often has rules about gate height, finish, and style, and some newer subdivisions near Sand Creek Road and Lone Tree Way review changes. Antioch’s city permitting applies mainly to new structures and electrical work, not like-for-like hardware repair. We can help you determine what your HOA requires, and we quote and agree the full price in writing before work begins.
Yes. Our techs handle the mechanical side – posts, hinges, weld points, and framing – and the electric side, including operators, limit switches, control boards, photo-eyes, and power runs. That matters on Antioch driveways where the wind pushes the gate into false obstruction cycles and the fix is usually both a sensor adjustment and a mechanical stop correction. Call (940) 412-7340 to schedule a technician.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Antioch Customers Say
"Our driveway gate stopped halfway and wouldn't close, which is a problem when it's the only thing between the street and the yard. They came out same day, replaced the motor, and it's smooth again."
- Leonard Pace"Gate wouldn't respond to the remote or the keypad. Turned out to be the control board. They had the part and swapped it the same visit. Quoted it first, no surprises."
- Everett Shaw"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike