Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Keene, TX
Gate repair in Keene, TX comes down to one thing more than any other: the ground the gate is set in. The Blackland Prairie clay under Johnson County expands and contracts with every wet and dry cycle, and that movement is what tilts gate posts, throws frames out of square, and pulls electric operators off their travel limits. Most Keene gates sit on ranchette lots of one to five-plus acres, so the work tends to be long driveway swing gates and slide gates rather than the small pedestrian gates you see in denser suburbs. If your gate won’t open or sags against the ground, call us at (940) 412-7340. We’ll tell you the price before any work starts.
Why Keene Homes Are Different
Keene sits on the southern edge of DFW sprawl, where Johnson County is still more open land than subdivision. The housing stock splits roughly in two: an older core of modest homes near the Southwestern Adventist University campus, and a newer wave of exurban construction on larger parcels as growth pushes south from Burleson and Crowley. On those larger lots, ornamental iron and galvanized pipe driveway gates are common fixtures, and they take a beating from the weather in ways city gates don’t.
North-central Texas summers routinely pass 100°F, which accelerates rust on bare metal and warps any wood components. Winter ice storms hit Johnson County harder than areas north of Fort Worth because of the slight elevation and open terrain. Those storms bend gate frames and knock electric openers off their travel limits. Then the wet-dry cycle resumes, and the expansive clay does its quiet damage. Gates that were plumb in March can be two to three inches out by September. It’s why we quote post-stabilization as a near-automatic line item on any repair estimate here, regardless of what symptom the customer first noticed.
Our Main Keene Services
The two calls we get most from Keene homeowners are sagging or stuck gates and electric openers that have quit responding, but we also handle full installations. Each service has its own Keene page with pricing and full detail.
Gate Repair in Keene
Most gate repairs in Keene start as a post or frame problem, not a hinge or latch problem. The clay shifts the post, the gate drops, and then the latch no longer lines up or the gate drags on the ground. We reset the post, square the frame, and replace whatever hardware the movement damaged. On manual pipe swing gates, that’s often hinge pins and latch hardware; on ornamental iron, it’s more often a cracked weld or a bent section. This is the work we do most days here, and it’s covered in detail on the Gate Repair in Keene page, including what a typical post-reset job runs.
Gate Installation in Keene
New gate installations on Keene’s larger lots usually mean a long driveway swing or slide gate, and the soil is the first thing we plan around. Posts need deeper footings and often helical anchors to resist the clay’s seasonal movement. We measure the opening, talk through manual versus automated options, and give you a written price for the full job before anything is ordered. If you’re on a newer exurban parcel or replacing an old pipe gate with something heavier, the Gate Installation in Keene page walks through what the process looks like and what drives the cost.
Electric Gate Repair in Keene
When an electric gate stops mid-travel or won’t respond to the remote, the Keene culprit is usually the opener’s travel limits after a storm, a failed capacitor from summer heat, or a photo-eye knocked out of alignment by post movement. Our techs carry parts and training for nine operator brands, so the truck that shows up already knows the system on your property. We diagnose, quote the repair in writing, and stand behind it for 365 days. Full pricing and common failure patterns are on the Electric Gate Repair in Keene page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Keene
We service most gate operators found on Keene properties, including LiftMaster, FAAC, BFT, Linear, and Mighty Mule, and we keep common parts for Viking, DoorKing, Ghost Controls, and Elite boards and arms in our DFW stock. That means most repairs don’t wait on a shipped part. See the full list on our brands page.
Pricing for Gate Company in Keene, TX
| Service | Typical range in Keene |
|---|---|
| Gate post reset and frame realignment | $250 - $600 |
| Swing gate actuator (arm) replacement | $450 - $900 |
| Slide gate motor replacement | $600 - $1,300 |
| Gate opener control board replacement | $250 - $650 |
| Photo-eye safety sensor replacement | $120 - $280 |
| Hinge and latch rebuild on pipe swing gate | $180 - $400 |
| Weld repair on ornamental iron gate | $150 - $450 |
| Electric gate travel-limit reset and tune-up | $110 - $250 |
| Full gate installation (manual, single swing) | $1,800 - $4,500 |
| Full gate installation (electric slide, long driveway) | $4,500 - $9,000 |
What pushes a Keene quote toward the top of those ranges is usually the post work. If the clay has moved a post two inches out, we’re pouring new footings and adding stabilization before we touch the gate itself. If the frame is straight and the post is solid, the price lands lower. Whatever the number is, you’ll have it in writing before we turn a single bolt. That’s the Kingswell Guarantee, and it’s stamped on every invoice.
Neighborhoods We Serve in Keene
We work all of Keene and the surrounding Johnson County acreage. Most of our calls come from these areas:
- The older residential blocks near Southwestern Adventist University
- The ranchette lots along County Roads 304 and 308
- Newer exurban builds south of Old Betsy Road
- Larger parcels east of I-35W toward Joshua and Alvarado
- The pipe-gate and iron-gate properties between Keene and Cleburne
For most Keene jobs, we can have a technician on-site same day or next morning. We give you a real arrival window when you book, not a four-hour guess.
Service Area – Cities Near Keene
Beyond Keene, our teams cover the surrounding Johnson County cities and northern Ellis County. If you’re in Cleburne, TX, Joshua, TX, Alvarado, TX, or Burleson, TX, the same written-price Kingswell Guarantee applies. Dispatch and scheduling are coordinated from our Dallas-Fort Worth office, and crews serve Keene locally.
Serving Keene, TX - Our Local Coverage Area
We’re based in the Keene area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Keene
Most Keene calls are scheduled same day or next morning. We give you a committed arrival window when you book, and a live person answers the phone 24/7. Call (940) 412-7340 and we’ll tell you the next available window before you hang up.
Most gate repairs don’t require a permit, but new installations with electrical or a driveway-width slide gate sometimes do. We handle the paperwork when it’s needed and can tell you upfront whether your job falls into that category. The zoning reality in Keene varies by lot size and road frontage.
Yes. We quote the job in writing before any work begins, and that number doesn’t change unless you ask us to add something outside the original scope. If the repair fails within 365 days, the return visit is free under our 365-Day Done Right Promise. That’s the Kingswell Way, and it’s the same at every independently owned Kingswell location.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Keene Customers Say
"Our driveway gate stopped halfway and wouldn't close, which is a problem when it's the only thing between the street and the yard. They came out same day, replaced the motor, and it's smooth again."
- Leonard Pace"Gate wouldn't respond to the remote or the keypad. Turned out to be the control board. They had the part and swapped it the same visit. Quoted it first, no surprises."
- Everett Shaw"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike