Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Lennox, CA
Gate repair in Lennox usually costs $180 to $640 for hinge and weld fixes, while a full operator swap on an electric gate runs $840 to $1,650. We’re Portcullis Gate Repair, a Kingswell company, and we work on the gates of this unincorporated community every week. Lennox is not Inglewood and it’s not Hawthorne. The housing is older, the air is salt-heavy, and LAX flight paths sit right overhead. All three leave a mark on gate hardware. Call (940) 412-7340 and we’ll give you a written price before any work starts.
Why Lennox Homes Are Different
Lennox sits directly under LAX flight paths, and that’s not a detail you can ignore when you’re diagnosing a gate. Gates here absorb continuous low-frequency vibration from landing and takeoff cycles all day, every day. Over years, that vibration loosens hinge bolts, fatigues welds, and cracks the concrete footings that anchor gate posts. We see failures in Lennox that would take a decade to develop in a quiet neighborhood a few miles inland.
Add the marine layer. Lennox sits roughly three to four miles from the Pacific, and the humidity rolls in most mornings and evenings. Bare steel and iron hardware oxidize relentlessly. There’s no freeze-thaw cycle here, so you won’t see frost heave, but rust and hinge corrosion are the dominant killers of Lennox gates. The housing stock compounds it: most homes and apartment buildings went up in the 1940s through 1960s, and a large share are rentals now. Wrought-iron driveway and pedestrian gates from that era are still hanging, often with decades of deferred maintenance behind them. One more thing that surprises people: Lennox is unincorporated, so gate and fence permitting goes through LA County Department of Public Works rather than a city building department. That changes setback rules and permit timelines for motorized driveway gates, and it catches plenty of contractors off guard.
Our Main Lennox Services
The two calls we get most in Lennox are for sagging or rusted iron gates and electric openers that have stopped responding. Here’s what each job involves.
Gate Repair in Lennox
Most Lennox repair calls start with a gate that drags on the driveway, a hinge that’s snapped, or a post that has started leaning. We cut out rusted sections, weld in new steel where it’s needed, reset posts, and rehang the gate so it swings true. On this side of town, corrosion near the bottom rail is usually the culprit, especially on gates facing west toward the ocean breeze. See what’s covered on the Gate Repair in Lennox page.
Gate Installation in Lennox
New gate work in Lennox usually means replacing a 50-year-old wrought-iron driveway gate with something that fits the property and meets LA County’s current setback rules. We measure the opening, build or order the gate, and set posts with the footings sized for this area’s soft, often salty soil. Permits for motorized gates go through the County, which adds time to the schedule. Find the full breakdown on the Gate Installation in Lennox page.
Electric Gate Repair in Lennox
When an opener quits in Lennox, vibration from the flight paths has usually done something physical: rattled a limit switch loose, cracked a solder joint on the control board, or shaken the actuator bolts out of alignment. We diagnose the operator and the wiring, then give you a written price before we turn a single bolt. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Details are on the Electric Gate Repair in Lennox page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Lennox
Our technicians arrive already familiar with the system on your property because we train across nine major gate-operator brands, including FAAC, BFT, Linear, and Viking. Common boards, limit switches, and remotes are kept on our trucks, so many Lennox opener repairs finish in one visit. See the full our brands page.
Pricing for Gate Company in Lennox, CA
| Service | Typical range in Lennox |
|---|---|
| Hinge replacement on a swing gate | $180 - $340 |
| Weld repair on an iron gate | $210 - $540 |
| Gate post reset | $390 - $780 |
| Cast iron welding, per joint | $120 - $210 |
| Slide gate roller replacement | $230 - $620 |
| Chain replacement on a slide gate | $240 - $430 |
| Electric opener board repair | $290 - $840 |
| Full operator swap | $840 - $1,650 |
| Loop detector replacement | $240 - $540 |
| Keypad and intercom replacement | $220 - $540 |
| Photoelectric sensor replacement | $180 - $360 |
| Complete gate installation | $2,800 - $8,500 |
Prices in Lennox run toward the mid-to-upper end of those ranges when salt corrosion has eaten into the frame and we have to cut back more steel than expected, or when a County permit for a motorized gate adds time and paperwork. You get the price in writing before any work begins, and that’s the price you pay. No surprises after we’ve taken the gate apart.
Neighborhoods We Serve in Lennox
We work across all of Lennox, from the residential blocks near Lennox Park to the mixed-use properties along Hawthorne Boulevard and the rental-heavy streets between the 105 and Imperial Highway. Most calls get a technician out within one to two business days, with emergency response available around the clock.
- Streets around Lennox Park
- Residential blocks north of Imperial Highway
- Properties along Hawthorne Boulevard
- Homes between the 105 and Lennox Boulevard
Service Area – Cities Near Lennox
Our Lennox crews spend most of the week in the unincorporated neighborhoods directly around LAX, but Kingswell companies also cover the wider region. We regularly coordinate dispatches with the teams in Los Angeles, CA, San Diego, CA, San Jose, CA, and San Francisco, CA for properties that stretch across county lines.
Serving Lennox, CA - Our Local Coverage Area
We’re based in the Lennox area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Lennox
Most non-emergency repairs in Lennox are scheduled within one to two business days. If a gate is stuck open at night or the opener has failed and left the driveway exposed, we treat it as an emergency and dispatch as soon as a technician is available. Call (940) 412-7340 and a live person answers, day or night.
Simple hinge replacements, weld repairs, and opener swaps typically don’t require a permit. New motorized driveway gates fall under LA County Department of Public Works because Lennox is unincorporated, and those jobs do need County approval before installation. We handle the paperwork and explain the timeline before you sign anything.
Yes. A large share of Lennox’s gate stock sits on rental properties, duplexes, and small apartment buildings, and we work with property managers and owners on those every week. We give a written price up front and a written guarantee on every repair, which matters when you’re managing a building you don’t live in yourself.
Every repair carries our 365-Day Done Right Promise, written on the invoice. If a repair fails inside that year, we return and correct it at no charge. That’s the Kingswell Guarantee, and it applies to every job we do in Lennox. Call (940) 412-7340 for a free estimate on any gate issue.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Lennox Customers Say
"Our driveway gate stopped halfway and wouldn't close, which is a problem when it's the only thing between the street and the yard. They came out same day, replaced the motor, and it's smooth again."
- Leonard Pace"Gate wouldn't respond to the remote or the keypad. Turned out to be the control board. They had the part and swapped it the same visit. Quoted it first, no surprises."
- Everett Shaw"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike