Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Southlake, TX
We’re Portcullis Gate Repair, a Kingswell company serving Southlake with gate repair, installation, and electric gate work. Most of what we see in Southlake is automated ornamental iron and steel driveway gates on large-lot estate homes built between the mid-1990s and 2010s. North Texas clay soil shifts constantly, pulling posts out of alignment and throwing operators off track. That means the work here looks very different from the average suburban gate job. Call us at (940) 412-7340 any time, day or night, and a live person will answer.
Why Southlake Homes Are Different
Southlake’s housing stock runs heavily to custom and semi-custom estates on generous lots, and the driveway gate was a standard luxury feature when these homes went up. That gives us a very specific mix of equipment: ornamental iron gates paired with automated swing or slide operators. A lot of those operators, particularly the worm-drive and linear actuator models installed in Timarron and similar developments in the early-to-mid 2000s, are now hitting end-of-life. We see actuator failures, stripped gearboxes, and control boards that stopped reading remotes years before anyone called us.
The soil under Southlake makes this worse, and it’s a bigger factor here than almost anywhere else in the metro. The expansive clay swells with spring rain and cracks hard in summer drought. Gate posts mounted in concrete footings get pushed a little at a time until the gate drags or the operator binds. Winter freezes add another layer; February 2021’s Uri left us replacing control boards and repairing cracked hydraulic lines across the area. If your gate worked fine for years and then suddenly didn’t, the answer is often in the ground underneath it.
Our Main Southlake Services
Southlake homeowners most often call us for two things: a gate that stopped moving, or a gate that needs replacing. Here’s how each works in this part of the metro.
Gate Repair in Southlake
Repair in Southlake usually comes down to one of three failures: an actuator, which is the motorized arm that physically pushes the gate open; a control board that no longer reads remotes or keypads; or a post that’s drifted out of plumb thanks to clay soil movement. Some of the actuator brands installed during the 2000s luxury-home boom are discontinued, so parts often come from specialty suppliers rather than a big-box shelf. When that’s not available, a full operator swap is the right call. We’ll tell you before we start, in writing, what each path costs. See Gate Repair in Southlake for full detail.
Gate Installation in Southlake
A new gate in Southlake means matching an ornamental iron design to a custom-built home, then sizing the operator to the gate’s weight and footprint. Lot sizes here mean most jobs are swings and slides, often with vehicle loops or keypad access already roughed in. Expansive soil makes footing preparation more than a formality; we pour deeper and let the base cure properly before mounting a post, because a fast-set footing in this soil eventually leans. We quote the full job before the first bolt is turned. Learn what’s involved at Gate Installation in Southlake.
Electric Gate Repair in Southlake
Electric gate work in Southlake tends to be about automation components rather than the gate itself. That’s limit switches, safety photo eyes, loop detectors, receivers, and the low-voltage wiring that Dallas heat and hard freezes degrade over time. UV cooks insulation; freezing water expands micro-cracks in housings. You end up with symptoms that look electrical, and they usually are, just not the part most people expect. We diagnose the whole system rather than swapping parts on instinct. More on what that covers at Electric Gate Repair in Southlake.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Southlake
Our technicians carry parts and service experience for LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. In Southlake, we see a steady run of Viking, Ghost Controls, and DoorKing units on older estate gates, and we keep common actuator components stocked in the truck. If we don’t have it, the local supplier network usually does. See the full list on our brands page.
Pricing for Gate Company in Southlake, TX
Southlake pricing tracks slightly above metro averages because of equipment mix and post conditions. Here are the ranges we quote most often:
| Service | Typical range in Southlake |
|---|---|
| Gate repair service call | $75-$125 |
| Actuator swap, parts and labor | $450-$900 |
| Control board replacement | $350-$700 |
| Post realignment and re-footing | $500-$1,100 |
| Hinge and weld repair | $200-$500 |
| Electric gate diagnostic | $100-$150 |
| Photo eye replacement | $150-$300 |
| Full operator replacement | $800-$1,800 |
| New gate installation, standard swing | $4,000-$12,000 |
| New gate installation, slide | $6,000-$15,000 |
What pushes price up in Southlake is usually soil-related post movement and the brand of the existing operator; discontinued parts cost more when they’re available at all. Every quote is written down and agreed to before we begin work. There is no surprise add-on at the end.
Neighborhoods We Serve in Southlake
We work across Southlake and the surrounding areas, from the estate lots of Timarron and Monticello to smaller amenity-heavy developments closer to Southlake Town Square. Response times run one to two hours for most repair calls, depending on where we’re coming from on that route.
- Timarron
- Monticello
- Carillon
- Westwyck Hills
- Southlake Woods
Service Area – Cities Near Southlake
We also serve the communities bordering Southlake, so when we’re in the area we can often schedule gate work the same week it’s requested. That includes Colleyville, TX, Grapevine, TX, Flower Mound, TX, and Roanoke, TX. Call and we’ll tell you how close our next Southlake route is.
Serving Southlake, TX - Our Local Coverage Area
We’re based in the Southlake area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Southlake
Most Southlake repair calls get a one-to-two-hour arrival window, and we hit that window because we tell you the truth about it when you call. Emergency calls are answered by a live person 24/7, including holidays.
Maybe. Many Southlake communities with deed restrictions, especially the estate-lot developments, require architectural review before a new gate or a visible operator swap. We can help with the equipment details, but approval goes through your HOA first.
Yes. The clay under Southlake expands and contracts with rain and drought, and that movement shifts gate posts and operator alignment over time. We check post plumb and footing stability on every repair call, not just the motor.
Gate acting up in Southlake? Call (940) 412-7340 for a straight answer and a written price before any work begins.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Southlake Customers Say
"Our intercom and gate motor both quit. They fixed the whole system in one visit and explained the warranty clearly. On time, polite, and tidy. Can't ask for more."
- Yvette Marchetti"Good repair on a sagging gate and a new hinge welded on. Took them a couple days to get the part in, but they told me that up front and it's been solid since."
- Hector Villanueva"The opener gave out and we were manually pushing the gate for a week. Portcullis got us in quick, swapped the opener, and set up the remotes for both our cars. Great to have it working again."
- Priscilla Nava